1- PRODUCT DESCRIPTION
2- WIRING DIAGRAM
Power supply 12-26 Vac/Vdc
Working temperature -20 : +70 (Deg C)
Reception frequency 433.920 MHz
No. storable codes up to 480 36mm
40mm
Relay contact Vac 1A 120V
Relay contact Vdc 1A 24Vdc
Absorption 60mA
1A - TECHNICAL FEATURES
Power +12/24Vac/dc
Ground
Indicating LEDs
Programming
button
Output 1
(use only dry contacts)
Output 2
(use only dry contacts)
Antenna IN
Antenna Sheild
3- REMOTE CONTROL PROGRAMMING
Every operation (both radio transmitter
NOTE: If a transmission is not made during programming the system will automatically exit after
5 seconds
programming and channel configuration)
is done by the button.
The programming is signalled by the color of
the led, in particular:
-Green led: the operations concerning channel 1.
-Red led: the operations concerning channel 2.
3A - INTRODUCTION
Press the Programming
Button Once:
THE GREEN LED
SWITCHES ON
While the LED is on,
press the desired Key
on the Remote Control:
THE GREEN LED
FLASHES BRIEFLY
Press Remote Control
key again.
THE GREEN LED
SWITCHES OFF
Press the Programming
Button Twice:
THE RED LED
SWITCHES ON
While the LED is on,
press the desired Key
on the Remote Control:
THE RED LED
FLASHES BRIEFLY
Press Remote Control
key again.
THE RED LED
SWITCHES OFF
3B - PROGRAMMING OUTPUT 1 TO A REMOTE CONTROL
3C - PROGRAMMING OUTPUT 2 TO A REMOTE CONTROL
Within 5 seconds
make a transmission
pressing the desired
button on the transmitter
(THE LED SWITCHES
OFF AND ON AGAIN)
Wait 5 seconds, or
push the button on the
receiver.
(THE LED SWITCHES
OFF)End programming.
Press three times the
button on the receiver.
THE LED FLASHES
ORANGE
THE LED FLASHES
ORANGE
3D - DELETING OF A RADIO TRANSMITTER
During the flashing,
keep the button on the
receiver pressed
until the orange led
becomes fixed on.
Release the button.
When the orange led
turns off, the memory
is erased.
Press three times the
button on the receiver.
The third time, keep
the button pushed.
3E - DELETING OF ALL RADIO TRANSMITTER
