LivingXL 500LB Supplement

500LB Executive Leather Chair

500 lbs on the product.

2
Base
Caster
Screw-30
Screw-35
Screw-55
M8*55mm
M8*35mm
M8*30mm
M
6
2
Back Cushion
Gas Lift
Gas Lift Cover
N

of the Seat Cushion (B) with Washers (L) & Screws
L
-50
(I) M8*30mm & Screws (J)M8*35mm by Allen
Wrench (M) (see Fig.1).
J
Push the plug to
L
L
K
M
I
I
J
L
D
B
K
K
J
underside holes of the Seat Cushion (B), ensuring
Assembly the Seat Plate (D) on the underside
Washers (L) and
Screws (I)M8*35mm(see Fig.2)
Using the allen wrench (M)
&Back cushion(A)
securely Screws(K)M8*55mm(see Fig.3)
N
N
the armrest
Align the holes of the Seat Plate (D) with the
that the "FRONT" label on the seat plate toward
the "front" side (see Fig.1)
Put the Back Cushion (A) align to the
seat Cushion (B) and make it towards
down. Assembly the Back Cushion's
L-Bracket to the Seat Cushion with Washers
(L) and Screws (J) M8*35mm by Allen
wrench (M). (See Fig.2)
Make the Arm r e s t' s holes（C &D) align to th e h o l e s
of the Seat Cu s h i on ( B) and Back Cushion ( A )
to assembl y S c r ew s (K) M8*55mm by Alle n W r e n ch
(M) to fix the a r m r es t.(See Fig.3)

The seat height can be adjusted between 21-24" by
Assembly the Caster (H) into the Base (G)
until fixed. Insert the Gas Lift (E) to the hole of
the Base (G) until it locks securely. Covered the Gas
Lift Co ver (F) on the Gas lift (See Fi g .4).
seat and back onto the gas Lift (F) and press down to secure in place
seat to make sure securing on the gas lift and not removable.
operate the right handle of the seat plate.(see Fig.6)
Operate the handle to raise the seat when the
Operate the handle to lower the seat when
Operate the left handle of the seat plate to locking
tilt control.
Operate the knob under the seat plate to
adjust tilt tension.
seat and back to make sure secure onto the gas lift and not
seat and back to make sure secure onto the gas lift and not
chair is empty.
to sit in.
Put the assembled seat and backrest onto the gas lift and press it down to check in place. Then lift the

To Disassemble the Chair
Fig.7
Fig.8
of seat plate.
(see Fig. 8). Gently tap the bottom of
the gas lift with a Rubber mallet (not
included) until the gas Lift is released
from the Base.
LivingXL Item #:X2267
Raise the seat to the highest level by handle
Angle and brace the Casters and Base
Brace/immobilize the Casters and Base.
Lift and remove the seat from the gas lift (see Fig.7).
Two persons required for disassembly.
3.
2.
1.
4.