User manual
5
4. Place the coffee cu to be used under the filter, ress the "single or double cu " button to reheat
the coffee machine and coffee cu through the outflow of hot water.
Making an espresso coffee
1. Fill the filter screen with coffee owder, and then smooth and com ress it.
2. Put the filter screen into the funnel; buckle it into the coffee machine from the "insert" osition;
and then turn it right to the "locked" osition.
3. Place the coffee cu to be used under the filter holder, ress single cu button, LED light of this
button will be on and others will be off accordingly at this time, machine starts to make single cu
coffee. When ress double cu button, LED light of this button will be on and others will be off
accordingly. At this time, machine starts to make double cu coffee. After making coffee, the
buzzer will ring three sounds.
Note: from the fourth cycle of making coffee (no matter single cup or double cup), need to wait for 20s
then can proceed to make coffee.
arning: Please do not leave the coffee machine when using it. Never remove the filter holder while the
appliance is delivering coffee.
4. Cold the machine for 5 minutes after finishing coffee , rotate the funnel to the left and take out,
hold the filter cu and our out coffee residue.
Making cappuccino
1. When finish reheating, ress steam button“ ”， then indicator light flashes accordingly, the
buzzer rang one sound. When the tem erature reaches to set value, the indicator light will always
on, the buzzer rang two sound. It indicates that users can start to make steam and can rotate steam
knob to adjust steam volume.
Pour the whole ure milk into the latte cu in reserve when the steam is reheated.
2. After steam finished reheating, rotate the "steam” knob counter clockwise to the maximum
osition to make the steam s ray for a while firstly, and then rotate the "steam" clockwise to the
OFF osition after the steam is uniform.
3.
Place
the steam tube into the latte cu , fix the mouth of the steam tube at 1 mm below the milk, and then
rotate the "steam» knob counter clockwise to the maximum osition.
After the steam is finished, and the steam preheating is completed, the coffee cannot be made
immediately. At this time, the machine will enter the protection mode due to the high temperature of
the machine. At this time, press the single cup or double cup button, the power and coffee indicator
lights are always on and buzzer rings three times as alarm. At this point, the machine will wait until the
temperature drops to the coffee temperature to enter the coffee mode.
4. There will be "hissing" sound at this time. The milk will form a vortex in the latte cu , indicating that
the air is entering the milk.
5. Wi e the steam tube and clean the residual milk with a dam towel immediately after making milk
foam, and then make steam for a while to kee the residual milk from clogging the steam nozzle.
