This is a remote controller that can generate radio wave carrying control
signal. After paired with a suitable Receiver, the remote controller can
control the Receiver by pressing on the remote. Each button of the remote
contains one unique code. The paired Receiver is capable to identify the
code and then take action accordingly.
Introduction:
* Line of sight from the Remote Control Unit to the Receiver is not required.
The control signal can pass through walls and ceilings.
* As with all RF transmitter devices, electrical fields, metal doors,
and motor devices can decrease the strength of the transmitting signal.
Reorient the Remote Control Unit may increase the control range.
* It is not guaranteed that every control signal sent out by the Remote
Control Unit will be received by the paired Receiver. Check to make sure of
the Receiver has responded after your press on the Remote Control Unit.
* If the LED indicator of the Remote Control Unit dimmed, replace the
battery according to the polarity sign on the battery apartment.
One new CR2032 lithium battery is needed.
Tips of using the Remote Control Unit:
This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and ( 2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the use's authority to operate the device.
Important Safeguards:
www.lockncharge.com
