LOFTWALL LAYER User manual

LAYER
ceiling mounting
Tools
Product
Styles
Warning It is important to utilize the correct screws for each
corresponding ceiling and oor surface. Screws are not
provided. Screws should be able to support 40 lbs of weight.
Power Drill
(Not Included)
Base
Pitch
Wave
Wire Cutters
(Not Included)
Crimper
(Not Included)

1 Loftwall | Layer Assembly Guide
Parts
List
Step 1 Step 2Using a bolt and nut, attach an adjustable clamp to the Layer
bafe using the precut holes. Repeat this process one more time
to complete step 1.
Before cutting wire, determine the desired length and add 2-3
more inches; this will allow wiggle room for hanging. Cut the wire
to the desired length making sure the wire lengths match.
Layer ceiling coupler assembly
Bafe Adjustable
Clamp
Wire Wire
Coupler
Ceiling
Coupler
Bolt Nut
Ceiling Coupler Assembly

Layer Assembly Guide | Loftwall 2
Step 3
Step 5
Step 4
Step 6
Using the cut wire, slide one end through the top of the clamp. To
adjust the wire push down on the top of the clamp and pull the
wire to its desired length. Do not cut any wire at this point in the
process.
Using a drill attach the upper half of the ceiling coupler to the
ceiling using appropriate screws for your ceiling. There is 31.5”
between each clamp.
Slide the bottom half of the ceiling coupler onto the wire, making
sure the threaded side is facing away from the panel. Crimp the
wire coupler to the end of the wire. Repeat
Raise the bafe and all attached parts to the ceiling and screw the
bottom half of the ceiling coupler into the top half.
Ceiling Coupler Assembly

3 Loftwall | Layer Assembly Guide
Parts
List
Step 1 Step 2Using a bolt and nut, attach an adjustable clamp to the Layer
bafe panel using the precut holes.
Before cutting wire, determine the desired length and add 2-3
more inches; this will allow wiggle room for hanging. Using wire
cutters, cut the wire to the desired length making sure the wire
lengths match.
Layer ceiling track assembly
Adjustable
Clamp
Bolt Nut Wire Wire
Coupler
Track Track
Coupler
Bafe
Ceiling Track Assembly

Layer Assembly Guide | Loftwall 4
Step 3
Step 5
Step 4
Step 6
Using the cut wire slide one end through the top of the clamp. To
adjust the wire push down on the top of the clamp and pull the
wire to its desired length. Do not cut any wire at this point in the
process.
Screw on the middle component of the track coupler to the
bottom component attached to the wire. Then screw on the top
component of the track coupler.
Using a drill, attach the track to the ceiling keeping in mind that
the panel will hang just below it. Be sure to use screws appropriate
for your ceiling material.
Using a drill, attach the track to the ceiling keeping in mind that
the panel will hang just below it. Be sure to use screws appropriate
for your ceiling material. If you are hanging multiple bafes, you
can also attach two tracks perpindicular to the bafes. Note that
the distance between each coupler is 31.5”.
Ceiling Track Assembly

5 Loftwall | Layer Assembly Guide
Step 7 Raise the panel and attached components and slide the track
couplers into the track. Postion the couplers so the wires hang
vertically. Tighten the track coupler by twisting the center
component against the track.
Ceiling Track Assembly

Layer Assembly Guide | Loftwall 6