Logic LGC-5565 User manual

INSTALLATION MANUAL
PUSH PULL WALL MOUNT
www.logicav.in
MODEL SERIES VESA DISPLAY SIZE MAX LOAD
LGC-5565 PUSH PULL 200x200 to 55” to 65” 110 lbs (50 kg)
WALL MOUNT 600x400

www.logicav.in
W-A: Concrete
Screw x 6
Right wall mount x 1
Left wall mount x 1
Connecting rod x 2
W-B: Fischer
expansion plug x 6
M-A: M8 X 25 x 4 M-C:
M6 X 25 x 4
M-E:
Knob x 4
Lock x 2
Checklist
1. Product Dimension
M-B: plastic x 4
Metal x 4
washer
M-D:
Plastic x 4
metal x 4
washer
W-C: Washer x 6
Right interface
bracket x 1
Left interface
bracket x 1
Dimension in mm
IMPORTANT : Prior to installation, ensure that you have received all the parts as per the checklist

www.logicav.in
Choose below method for fixing wall mount.
ATTENTION: Drilling the wall for the wall mount should be executed by a craftsperson only
Exercise care to prevent any scar or damage to the wall.
2. Installation
CAUTION : Wear safety glasses while operating power equipment.
Failure to comply may result in eye injury
1. Place the right and left mount on the wall, the lock system should be indicate right and left mount
2. Place the unit on the wall and make marks on the wall.
Note: While marking make sure the mount is placed in a straight line using the surface leveler
If your using sliding plate LGC-5565SP keep 700mm gap in between the right and left mount
(Refer sliding plate drawing)

www.logicav.in
3. Drill the wall and insert the Fischer expansion
plugs into the holes place the mount on the
wall and insert concrete screw. (Refer W-A,
W-B, W-C in the checklist)
4. Insert the connecting
rod into the wall rail

www.logicav.in
5. Screw the knob to the connecting rod
(Refer knob M-E in the checklist)
6.Place the interface bracket on the
TV/ display and insert the washer and screw
(Refer the checklist for the suitable screw and washer)

www.logicav.in
7. Rotate the interface bracket both the knob anti clock wise and adjust for the required
angle than rotate clock wise for tighten the knob
8. Rotate the screw using alien key for height adjustment of 25mm
Angle adjustment details

www.logicav.in
9. Rotate the screw using alien key for angle adjustment.
Height adjustment details

10. Place the top side of the interface on the top connecting rod and than pull the lock
as shown in image and place on the bottom connecting rod
11. After finishing the installation place
the lock on the mount as shown in image.
Final view after installing the mounted display on the wall
www.logicav.in