78
26
1
5
34
9
11
18
19
28
17
12
16
13
20
21
22
26
29
32
31
30
27
24
23
28
25
34
33
1. Drag knob
2. Locking screw M3x5
3. Drag knob nut
4. O-ring
5. Nut washer
6. Click bush
7. Click pin
8. Click spring
9. Stop pin
10. -
11. Housing
12. Foot
13. Foot screw
14. -
15. -
16. Seal ring
17. Ball bearing
18. Steel plate
19. Ball bearing
20. One way clutch ass'y
21. Carbon plate
22. Bearing holder
23. Cup spring
24. Draw bar
25. Spool
26. Spool cap o-ring
27. Spool cap
28. Handle rivet, balance screw
29. Handle rivet
30. Handle knob washer
31. Handle knob
32. Handle knob screw
33. Balance
34. Balance o-ring
LOOP OPTi Fly Reel Manual
Congratulations on the purchase of your new flyreel. We wish you many seasons of good use of
your new reel in flyfishing. Enclosed are instructions for proper care and maintenance. Good luck!
Conversion left / right hand retrieve:
1. Remove spoolcap (27).
2. Pull spool (25) straight out.
3. Release stopscrews (2) ½ turn with enclosed Allen wrench.
4. Pull drag knob (1) straight out.
5. Remove drag knob nut (3).
6. Pull draw bar (24) straight out, together with cup springs (23).
7. Pull bearing holder (22) straight from shaft (15).
8. Remove seal ring (16).
9. Remove bearing (17), bearing washers (18), carbon plates (21) and one way bearing (20).
10. Turn one way bearing (20).
11. Wipe clean.
12. Assemble the reverse way.
Adjust the effect of the brake:
The drag knob nut (3) allows you to adjust
the brake, in order to obtain the lowest brake
effect of preference. We recommend free
spool in both directions.
1. Turn the adjustment screw (3) until
the lowest preferred brake effect has been
obtained.
2. Fasten the drag nob to the ajdustment
screw and turn the handle counter clockwise
so that the heel on the inside of the drag nob
(36) will settle to the left of the stop pin (9).
Tighten the screws on the lock with the Allen
wrench. 9
3
36
For more info on Loop fly tackle and accessories: www.looptackle.se
Maintenance of the reel:
• This reel is contructed so that maintenance is kept to a minimum. However, be sure to check
on the level of grease on the O-ring (26) inside the spool cap (27), after using the reel for
some time. We recommend Molykote 111C grease or similar.
• Put grease on locking screws #2 and the threads on drag knob #1 before use in saltwater.
• Rinse reel after use in saltwater. Do not remove the spool, water may penetrate the drag
system.
• After fishing or when stored, make sure to release the pressure on the drag system.
Caution! Do not touch any moving parts of the reel when a fish is running.
