loox 833.89.122 Installation manual


11/4/2015
Page
1
LOOX Mounting / Programming Instructions: Item no. 833.89.122
The following are programming instructions for the Wireless Remote
Switch for the Multi-Zone White Light Dimming Control System.

The Wireless Remote Switch, item 833.89.122, works with both 12v
(833.73.741) and 24v (833.77.785) receiver modules. Surface Housing
(833.89.123) Sold separately.
Up to 10 Receivers can be paired to a single Wireless Remote
Switch.

Multiple Wireless Remotes (hand held remotes [833.89.121] and
remote switches [833.89.122]) can be paired to each Receiver
Module.



11/4/2015
Page
2
LOOX Mounting / Programming Instructions: Item no. 833.89.122

Installing the Battery
To install or replace the battery (type CR2032, 3V), remove battery
cover as shown.
Pay attention to battery orientation (+ faces the battery cover).
Replace battery cover and turn until the cover is secure.


Pairing the Wireless Remote to the Receiver Module:
Rotate dial on the back of the Wireless Remote Switch with small flat
blade screw driver to position 7.
Press button located on Receiver Module Top Cover.
Button will flash blue....
Press top button on Wireless Remote Switch.
The Blue light on the Receiver Module will turn off.


11/4/2015
Page
3
LOOX Mounting / Programming Instructions: Item no. 833.89.122


Test the pairing by pressing the power button for on and off.
[Turning the dial to 0 for all zones or individual zones (C1, C2, C3…
1, 2, 3…) (Dial position 1 = C1 etc., Dial position 0 = all zones)]. Note:
C1 will turn all C1 lights on /off etc.


Operation and Dimming:
Pressing the power button briefly turns lights off and on.
Dimming all lights or selected zones can be achieved by pressing
and holding the power button for all zones (0) or individual (C1, C2
C3…1, 2, 3…) for greater than 1 second.
The dimming is not cyclical. Holding the button initially only dims in
one direction. To reverse the dimming, re-press the same button
longer than 1 second to increase the light intensity.


11/4/2015
Page
4

LOOX Mounting / Programming Instructions: Item no. 833.89.122
Installation:
The Wireless Remote Switch can be recessed or surface mounted
with housing 833.89.123.


Resetting the Wireless Remote Switch:
It is also possible to reset a remote and break communication with
all associated Receiver Modules.
Rotate the dial on the back of the Wireless Remote Switch with a
small flat blade screw driver to position 8.
Press top button on Wireless Remote Switch.