LOUQE RAW S1 User manual

LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
USER MANUAL
RAW S1
LQ-RAS101-CA-0GG
1

RAW S1 USER MANUAL
BOX CONTENT
INSIDE PLASTIC BAG
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
2
LOUQE RAW S1 Case
T10
Torx key
8x
M3x8 button head 4x
#6-32 UNC

RAW S1 USER MANUAL
ILLUSTRATION
ASSEMBLY STEPS
•Place the case upside down
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
SCREWS
None in this step
3
CLOTH
NOTE: Place the case on a cloth to avoid scratches

RAW S1 USER MANUAL
ILLUSTRATION
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
4
SCREWS
None in this step
ASSEMBLY STEPS
Detach the USB-C extension cable
•Lift the quick lock
•Pull out the USB-C extension cable from its position

RAW S1 USER MANUAL
ILLUSTRATION
ASSEMBLY STEPS
Detach the power button
•Lift the quick lock
•Apply inwards pressure on the power button to tilt it
inwards
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
5
SCREWS
None in this step
NOTE: Make sure that the aluminum button clears the unibody

ASSEMBLY STEPS
•Unscrew the screws in the corners of the case
RAW S1 USER MANUAL
ILLUSTRATION
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
6
SCREWS
x4

RAW S1 USER MANUAL
ILLUSTRATION
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
7
SCREWS
None in this step
ASSEMBLY STEPS
•Pull out the core from the unibody by the handle

RAW S1 USER MANUAL
ILLUSTRATION
ASSEMBLY STEPS
•Install the motherboard I/O shield included with
your motherboard
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
8
SCREWS
None in this step

RAW S1 USER MANUAL
ILLUSTRATION
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
9
SCREWS
x4
ASSEMBLY STEPS
•Install the motherboard by aligning it with the I/O
shield and screw it in place using four M3x8
button head screws
•Connect PCI-e riser cable into the motherboards
PCI-e slot
NOTE: Make sure no wires extend outside of the blade edges

ASSEMBLY STEPS
•Connect the power button switch cables to your
motherboard’s PWR SW pins.
RAW S1 USER MANUAL
ILLUSTRATION
LOUQE AB
Lövgatan 30, 169 32 Solna Sweden
[email protected] www.louqe.com
10
SCREWS
None in this step
PWR SW
NOTE: You may need to consult your motherboard user manual