ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0324 / T0325
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
161227
Cross Bar(A)
Green Grounding
Screw (C) Headless Screw(E) Ball Nut(G)
Mounting Screw (B) Wire Nut (D) Lock Nut (F)
Rubber Pad (H)
Seeded Glass
Fixture
Rubber Pad
Ball Nut(G)
(H)
Fixture Wire
Wire Nut (D)
Fixture Grounding Wire
Headless Screw (E)
Cross Bar (A)
Lock Nut (F)
Outlet Box
House Grounding Wire
Green Grounding Screw (C)
Mounting Screw (B)
Lock Nut-2
Set Screw
Loop
Washer
Curved Arm
Bulb Type A Max.60W
(not included)
Turn off the power at fuse or circuit box.
1. Thread two headless screws through the cross bar, then secure them with four lock nuts ( two on each side of the
cross bar). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be level.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Unscrew the set screw，lock nut-2 and washer.
4. Hook the curved arm to the loop, and then attach the curved arm to the back plate by using the set screw, washer
and lock nut-2.
5. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the cross bar with the green grounding
screw. Then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
Back Plate
Installation Steps
