Lowel PRO Power Led User manual

Lowel PRO Power LED I structio s
The Lowel RO™ ower LED
is a professional AC/DC powered
lighting fixture. Read these instruc-
tions before operating.
n Not for house hold use,
use only for professional imaging
purposes.
n Do not immerse unit in water
or use in damp locations.
n Do not obstruct heat ventilation
for unit.
n Do not stare directly into LED’s.
n Always remove batteries
or AC supply, and make sure unit
is powered Off when not in use,
or being stored.
War i gs
Yellow Dot = Tungsten Model
Code: G5-10TU
Blue Dot = Daylight Model
Code: G5-10DA
Lowel RO ower LED is available as
either a tungsten color, or daylight color out-
put model. In either case, color does not shift
as the light is dimmed.
An 82mm filter can be attached to the screw
thread on the front of PRO's fresnel lens.
This allows color conversion filters, to turn a
tungsten light to daylight and vice versa.
Daylight / Tu gste Filter Co versio
n Steady Green – Unit is ON and has
sufficient power (battery or AC)
n Slowly Flashing Green – Unit has
battery power for aprox. 10 minutes at full
brightness
n Fast Flashing Green – Unit has battery
power for aprox. 2-3 minutes at full
brightness.
n Flashing Red – Unit is overheating and
is about to shut down. Turn Power Switch
OFF and let unit cool for 10-15 minutes.
I dicator Lamp
Fold down 1/2 yoke to mount PRO Power
ED on 5/8" stand stud. Tighten knob
securely. Fold down rear handle to assist in
tilt & focus control. Attach power cord from
AC supply (Or Battery Accessory) into the
jack on the rear of the light, making sure
to correctly orient the mini-X R plug.
Turn PRO on with the On / Off Switch,
and adjust dimmer level for desired output.
Color temperature will not shift during
dimming.
Operatio
Focusi g
Weight (w/barndoors): 3.3 lbs (1.5 kg)
1 owel PRO (Tungsten or Daylight) with
auto-setting AC adaptor (G5-80), and 2 Way
Barndoors (G5-25)
Voltage: 24 V
Wattage: 22.4 W
Amperage: .7 A
Beam control: Continuously variable
Fits on: 5/8 stand studs, also 1/4-20 Pistol
Grip mount
Materials: Primarily aluminum steel,
& glass-filled nylon
Dimming Control & Switch: in-unit
Installed LED Lumen information:
2292 lumens (3000K Tungsten Model)
2500 lumens (5000K Daylight Model)
both at 700mA drive current (17.6W)
Lowel PRO Accessory
Battery System
Code: G5-156
Weight: 3.6 lbs (1.6 kg)
Battery box with 7ft DC cord, attached stand
mount clamp, air-cushioned shoulder strap,
and removable PRO ED ong ife Battery
(G5-15). Supplied with owel Rapid Charger
100 (G1-18)
Lowel PRO Spare Batter
Code: G5-15
Weight: 1.5 lbs (.7 kg)
Lowel PRO Spare Batter Box
Code: G5-17
Weight: 1.3 lbs (.6kg)
Rapid Charger 100
Code: G1-18
Weight: .8 lbs (.4 kg)
Poweri g PRO Power LED by Battery
Lowel RO ower LED is a focusing fixture with a spot to flood ratio of 5:1.
To focus, hold the light by its rear handle as you grasp the front of lighthead and slide it for-
ward to spot, or backward to flood the beam.
Focusable
ED Head
with Fresnel
ens
Accessory Slot
Diaphragm
Cooling
Fold Down Handle
Tilting Half Yoke
1/4-20 Screw
Thread
Barndoor Frame
Attachment Ring
Folded for storage with Barndoors attached.
Spot
Flood
Dimmer Knob
On/Off
Switch
Indicator
amp
Power In
Specs & Daylight & Tu gste Models

Light Co trols
Recomme ded Mou ts
Lowel PRO Ha dle
Code: G5-41
For hand holding owel PRO Power
ED. Handle with 1/4-20 screw-
threaded post, attaches to underside
of light.
Bar doors
Use the clip-on 360° rotating
barndoors to trim unwanted output spill,
(for example: to reduce risk of shadow in
your shot caused by use of overhead boom
microphones). The 2 doors are spring
clipped to the rotating frame, and can be
repositioned as needed. They will expand
for use with PRO's wide flood beam.
To remove the barn door
frame from the light,
loosen the locking knob
sufficiently to release the
spring tension of the
frame. When reattaching,
make sure the guides
of the frame are fully
resting in the recessed
groove of the frame
attachment ring.
PRO Expa dable
Bar door Leaf
Code: G5-24
To supplement the 2 supplied barndoors
for 3 or 4 door use. Can also combine with
PRO Gel Frame & diffusion to create smaller
soft box effect.
Tota-clamp
Code: T1-30
Weight: 4 oz (113 g)
Clamps onto pipes and objects
up to 1 7/8" (4.8 cm) thick.
Safety Cable (3)
Code: CM-50
Size: 34" (86.4 cm)
Braided stainless-steel cable adds
security to lights and accessories
that are attached to overhead pipes,
beams, dropped-ceiling grids, etc.
(Set of 3).
For location studio use, hang PRO ED upside down from Tota-clamp. Always use securely
with Safety Cable, looped thru the hole in the stand yoke, and around the pipe.
U i TO Sta d
Code: UN-55
Size: 21.5" (54.6 cm)
folded.
Maximum height:
7'11" (2.4 m)
Base diameter: 43"
Tota-brella
Photographic umbrellas convert relatively
hard light sources, such as spotlights, into
relatively soft sources that provide soft shad-
ows and highlights.
Silver Code: T1-25,
Reflective umbrella.
White Code: T1-26
White nylon umbrella that produces a softer
light and also may be used as a large dif-
fuser.
To Mount Umbrella
insert umbrella shaft into PRO's Accessory
Slot, and lock with knob.
PRO LED Gel Frame
Code: G5-40
Holds 5 x 6" gels. Unfold
frame, extending frame bar and
insert through Accessory Slot.
ock with knob. Pans and tilts
with the light, collapses for
storage.
PRO LED Gels
Code: G5-78
For correcting tungsten to daylight color
Code: G5-79
For correcting daylight to tungsten color
90 Oser Avenue, Hauppauge, N.Y. 11788
Call: 800 645-2522 or 631-273-2500
Fax: [phone]
e-mail: [e-mail]
www.lowel.com
Lowel-Light Ma ufacturi g, I c.
Lowel PRO Power LED I structio s
Ver. 1.0 © 2014 owel- ight Mfg, Inc. 276
Focus PRO ED to Flood posi-
tion to fill diffuser screen with
light output.
Collapsible softbox attaches easily
to PRO Power ED Accessory slot
and sets up quickly, to give soft
flattering output.
PRO Power LED Softbox
Code: G5-30
Weight: 1.2 lbs (.6 kg)
1 Full Day Blue,
1 1/2 Day Blue,
1 1/4 Day Blue,
2 Frost
1 Full CTO
1 1/2 CTO
1 1/4 CTO
2 Frost