Loxit 8990 User manual

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
Slim Wall Mount 8990 - Instructions
Bolt the adjustable position
brackets to the back of the
VESA mount plate using four
M8*16mm bolts.
1.
2.
Bolt the legs into place with four
M8*16mm bolts. Make sure that
the bolts are in the correct hole
for the angle you require
There are 3 positions which
allow the screen be mounted
with 0 or 5 or 10 degrees tilt.

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
3.
Screw an adjustable foot fully into
the bottom of each leg
4.
Attach the mounting plates in using
sixteen M5*12mm screws

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
5.
Secure the wall mount at a
height of 1390 mm to the center
of the mount, ensure the mount
is level
Attach the easy install kit to the
mount using two M8*16mm
bolts in the holes shown
6.

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
7.
Attach the easy install kit and
mount to the upper mount as
shown using two M8*16 bolts
Secure the lower
mount to the wall
Unbolt and remove
the easy install kit
8.

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
9.
Bolt the screen mount and
cover to the wall using
four M8*16 bolts
10.
Screw two M8*16 bolts
part way into the power
bar as shown

Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ [email protected]m ꞁ [phone]
11.
After attaching the cables
to the power bar, lower
the power bar down
behind the screen mount
Locate the bolts through
the holes shown and
lower the power bar into
position
Tighten the bolts