About the product
Connect up to 128 Loxone Air devices using the Air Base
Extension.
Installation
The installation of the device has to be mounted on a DIN rail
in an electrical distribution housing and may only be
performed by qualified personnel.
Protection against electrical contact and fire protection must
be provided in the final installation by the use of a standard
compliant/approved housing.
If the unit is used in a non conform manner as specified by
the manufacturer the product included safeguards will be
impaired.
For additional information, declaration of confirmity,
visit www.loxone.com/help/air-base-extension
Connection
Temperature resistance -40 … 105°C / -40 … 221°F
Stripping length 5mm / 0.2“
Air Base
Extension
SMA connector
for antenna
Wire cross-section 0.25 ... 0.8mm² / AWG23 ... 18
This folder is a part of the product!
Power
Supply
+24V
GND
Loxone
Link
BU
WH
Information
Contains FCC ID: COR-ZWIR4512AC1
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
2.
This device may not cause harmful interference
This device must accept any interference received,
including interference that may cause undesired operation
