LOXONE Weather Station Air User manual

Part No.: 100245
Need Help?
loxone.com
No Gimmicks.
Real Smart Homes.
Weather
Station Air
Technical Specifications
Power Supply 10...30VDC SELV or
2x 1.5V AA batteries
Power Consumption typ. 0.07W, max. 1.1W (when
rain-sensor heating is on)
Battery Lifetime Approx. 2 years
Heating of Rain-Sensor Surface Yes, only when SELV powered
Radio Frequency 868MHz (SRD Band Europe),
915MHz (ISM Band Region 2)
max. Power 3.16mW
Safety Rating IP44
Ambient Temperature -30...85°C / -22...185°F
(if SELV powered)
-20...54°C / -4...129°F
(if battery powered)
Wind Detection Range 9...145km/h / 5.6...90mph
Brightness Detection Range 0...188kLux
Temperature Detection Range -40...125°C / -40...257°F
Maintenance & Cleaning This device is free of main-
tenance and may only be
cleaned with a dry cloth.
Loxone Electronics GmbH
Smart Home 1
4154 Kollerschlag
Austria
loxone.com/support
Information
Contains FCC ID: COR-ZWIR4512AC1
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired operation
Weather
Station Air
Part No.: 100245
Station Air
Connection
Wire Diameter 0.14²...1mm²
AWG18...AWG25
Exposed Wire Length 7mm / 9/32”
Push-In-Technology To make connection, insert
the wire; to remove the wire
twist and pull at the same
time.

About the product
The Weather Station Air detects important weather conditions
for your Smart Home. Together with the Miniserver, you can
measure wind, rain, brightness and temperature data, and use
this data for a variety of functions throughout your home.
Features
• Wind sensor
• Wind alarm
• Rain sensor
• Brightness sensor
• Temperature sensor
Information
Please note that the temperature sensor may not always
accurately record the external temperature. This is due to
direct sunlight warming the housing, which can influence the
temperature reading. Always select an installation place that’s
suitable for the application.
Installation
We suggest you install the weather station in a place where
wind, rain and brightness can be detected without interference.
Install and connect the device as shown, either on a pole or
directly on the wall, with the provided accessories. Please note
that buildings or objects in close proximity to the Weather
Station could cause air turbulence which may influence the
accuracy of wind measurements.
For additional information, declaration of confirmity,
visit www.loxone.com/help/weather-station-air
Now pair the Weather Station with your Miniserver via Loxone
Config.
You can also power the Weather Station Air with the AA bat-
teries (included), but please note that due to the higher power
consumption required, the anti-condensation feature which
heats the rain sensor will not be possible. As well set the wind
alarm speed on the device manually by adjusting the potentio-
meter settings.
Left stop of potentiometer for 1, right stop for 5
GND 24V
Push on both sides and
pull to open the top
Push and pull
to unlock
Switch set to LX
Status LED
Learn Button
Wind-Alarm
potentiometer
Preferred:
Wired Power
Connection
Wind-Alarm
Potentiometer Settings Threshold in km/h / mph
1 20 / 12.4
2 25 / 15.5
3 30 / 18.6
4 40 / 24.9
5 65 / 40.4