LP TENT Airtents User manual

2. Installation Of The Top
Pieces
1. Opening The Air Tent
x1
x1
x1
x1
x1
x1
A.Frame
B.Top
C.Pump Adaptor
D.Carrying Bags
E.Pump
Roll out the frame so that the 2 Blue marked D rings are on top
in the middle of the X pattern. The air valves (2) should
be pointing to the ground.
Unfold and tie the center of the top to the 2 Blue marked D rings in the
center of the frame. Place the top on the frame and
secure the Velcro straps (1) from 3 of the arms to the Blue marked D
rings (2) on 3 of the frame legs.
*Be sure there are no twists in the legs
**Be sure that all the vents are in locked close position and caps are on tight.
2
1
2
2
AIR
Assembly Instructions for Airtents

3. Inflating The Tent
Attach the pump adaptor to
the end of the pump hose.
Remove the cap from the valve (1) directly below
the emergency release valve (2). Attach the vent
to the valve (1) to inflate the tent.
Pump the frame with air until it’s full.
1
1
2
AIR
Assembly Instructions for Airtents

Wall Installation
Aditional Notes
If you’re using and electric pump:
AP2000 BASIC - Once attached to the frame turn the pumps yellow on and fill the tent until the tube is inflated. On 6m and 8m
tents you will need to engage the red switch to allow maximum PSI to fully inflate.
AP2000R REGULATOR - Once attached to the frame turn the power switch on. The hold the “auto cycle on/off” button down for
2 seconds or until the pump engages. Fill the tent until the tube if fully inflated.
* When the frame is almost full and starting to lift you’ll need to get under the center and push up to get the tent to lift.
** As soon as the tent lifts turn off the pump and check the tube to see if it is fully inflated. If it has been filled over its maximum
the emergency valve will vent off any excess pressure.
*** It is VERY IMPORTANT that the pump be turned off immediately after the emergency valve starts to vent. The pump can now
be removed from the tent. Make sure the valve is closed and the cap is on
Walls zip directly to the Airtent top. Pick the side you want to place your wall on, and zip.
AIR
Assembly Instructions for Airtents

Fix the straps to the Red marked D Rings and place the stakes at
an approximate distance of 3ft from the legs.
Advised Securing Procedures
Rope andPeg Kit system
for securing the tent.
Water Weight Bag. Attaches to
the base of the airtent frame.
Assembly Instructions for Airtents
AIR