LP TENT MAGICIAN XP Series Manual

MAGICIAN SET UP
MODELS: XP220, XP330, XP345, XP360
www.lptentcanada.com/www.lptentusa.com

VISIT THE SUPPORT PAGE AT LPTENTUSA.COM / LPTENT.CA FOR MORE INFORMATION ON LP TENT PRODUCTS.
POP UP TENT |Magician (XP)
Thank you for choosing the Magician.
The Magician pop up canopy tent is ideal for intensive
use where there is a daily requirement to shelter areas
quickly and efficiently; The XP Magician includes
several LP TENT patents making this canopy tents
design unparalleled. Its many strengths make it the
best selling tent to date.
For an optimal use of this product we invite you to
follow our setup guide.
Door Wall Attached
Using Keder System
& Velcro
Reinforced Corner and
Connection Fabric
Reinforced
Aluminum Scissors
Aluminum Integrated
Counter
Integrated Walls
Using Keder System
Aluminum Frame
Reinforced By Grooves
Stainless Steel Screws
Window Wall
Attached Using Keder
System & Velcro Fiberglass Injected
Connections
Anchor Points
Full Wall
Attached Using
Keder System
& Velcro
Self Locking
Fiber Glass
Injected Corner
Steel Foot Plates

VISIT THE SUPPORT PAGE AT LPTENTUSA.COM / LPTENT.CA FOR MORE INFORMATION ON LP TENT PRODUCTS.
Open the structure 60% of the way then position 2 people face to face, grab the scissors and pull while backing up.
Do not tighten the Velcro on the roof
during the assembly of the canvas.
Deploying the structure
With two people, open the roof and grab at each corner.
Correctly position the peak and the corners of your top.
Open the frame 40% of the way
Position the frame
Once each corner of the top is correctly placed on the corners of the structure (A) attach the Velcro
straps in the corners like as shown above (B), finally open the tent all the way and attach the
Velcro straps in the center of the valences to the scissors like as shown above (C)
Position the top Secure the top to the frame
SET UP INSTRUCTIONS |Magician (XP)
FRAME DEPLOYMENT
TOP INSTALLATION
1 2 3
1 2
Place the tent on a flat surface,
standing upright on its 4 feet. Then
loosen the roof strap.
Position the frame
A B C
Do not grab or pull at feet.

VISIT THE SUPPORT PAGE AT LPTENTUSA.COM / LPTENT.CA FOR MORE INFORMATION ON LP TENT PRODUCTS.
Push point A) towards point (B) until you hear a click. Once you hear the click the XP automatic
locking system will be locked into place and your tent will be secure (C). Repeat on all legs.
Adjust the height of the tent using the extendable legs. To do this, push the pin on the leg inwards
(A) and slide the lower part of the leg (B). The lower part must slide by itself.
You can choose between 3 height settings.The walls are provided for the maximum height. (When
extending the legs do not stand on the foot plate)
XP automatic locking system Height adjustment
Position the wall so that the Velcro strip on the top faces the
outside of the tent. Insert the keders into the frame (A) (INSERT
MID FRAME) and attach the Velcro to the roof strip (B) (Inner side).
Insert the wall keders into the frame Attaching the wall to the bottom of the leg
Wrap the bottom of the wall around the bottom of the leg and
attach it to the inside of the wall. If there is more than one wall,
attach the Velcro to the adjacent wall.
Unzip the two vertical zippers (door only), roll the door/curtain and
hang it with the Velcro strips on the top of the wall.
Opening the door/window wall curtain
Do not force the frame. Close the
frame and check for blockage
WALL INSTALLATION
FRAME DEPLOYMENT
3 4
1 2 3
A
B
A
B
C
SET UP INSTRUCTIONS |Magician (XP)
A
B

VISIT THE SUPPORT PAGE AT LPTENTUSA.COM / LPTENT.CA FOR MORE INFORMATION ON LP TENT PRODUCTS.
Place the weight on the foot plate of your tent (A). Stack any extra weights if necessary. Attach the carabiners to the anchor points on each corner of the tent (A). Place the stakes at a
minimum distance of 3ft.
Weighting Anchoring
• Wash with a damp cloth and soapy water (no abrasive sponge or
detergent).
• Rinsing possible with a hose (high pressure not recommended).
• Air dry before storing.
• To remove dirt, grass, clean the frame with a damp cloth (No
detergent).
Cleaning the roof, walls and frame: Storing: Transportation:
• Wash and dry before storing.
• Store the tent upright in its carrying case.
• Store the material in a dry place not subject to high humidity.
• Transport the tent preferably upright.
• In case of horizontal transport, do not put weight on the structure.
CLEANING & MAINTENANCE
WEIGHTING & ANCHORING
1 2
1 2 3
AA
SET UP INSTRUCTIONS |Magician (XP)