8. This can be done by pressing and holding one of the buttons
and then pressing the other button multiple times. Each time
the second button is pressed, the unit cycles through vibration,
tone, low-volume speech, mid-volume speech and high-volume
speech, and then back to vibration mode
9. In vibration mode, denominations are announced by a pattern of
vibration pulses and in tone mode, by a pattern of tones of
different pitch and duration
10.If a bill is either not inserted or is not identifiable, the unit speaks
“Error” or provides a vibration or tone pattern.
11.To change the battery, open the compartment on the bottom of
the unit by sliding open the door. Pull on the silk strip to release
the battery and insert a fresh AAA battery. The negative
terminal of the battery (flat end) should be inserted first into the
compartment and then the positive terminal.
12.The announcements and indications are shown in the following
table
