Ltech HS-ZB-A User manual

Manual
Re-set hole
3M back glue
Indicator
light
You can place the motion sensor
at will for its free installation.
Before using, please open the back
cover and pull out the insulation.
HS-ZB-A
Motion Sensor
2
Product Introduction Operating Schematic
The motion sensor adopts thermo-electric infrared sensor to
detect someone’s passing via sensing heat. Achieve light on
during someone coming and light off as someone left through
linkage of gateway with intelligent device and lamps, you can
set trigger conditions, trigger period and shutdown delay via
the APP, it makes life smart.
Unit: mm
3 4 5
1.
2.
Low Power Detection
Long press re-set hole for 5 seconds, the indicator light is on
for 1 second, means factory setting is restored.
Indicator:
Detecting distance : 4M
Product Parameters
Detecting Distance:
100 degrees
Above 1 year
Detecting Angle:
Standby Power:
4m
Model:
Working Voltage:
Wireless Type:
Working Temp.:
Dimension :
Packing：
Weight (G.W.) :
3Vdc (CR2450 battery)
zigbee (802,15,4)
-5℃~45℃
L66×W66×H22(mm)
L68×W68×H22(mm)
65g
HS-ZB-A
Product Size
Restore Factory Setting Attention
The indicator light flashes every 6 seconds, means the battery is not
enough, please replace the battery.
Detecting Range
Detecting angle :100 degree
(three-dimensional)
Motion sensor is easily affected by heat and light, so pay
attention to surrounding environment (such as radiator, heater,
air conditioning, the sun, incandescent lamp, etc.) to avoid the
false positives for large varies of environmental temperature.
After the low power prompt, the motion sensor will no longer
enter the trigger work, please replace the battery.

76 8
9 10 11
23
4 5
1
Warranty Agreement:
1. We provide lifelong technical assistance with this product:
A 3-year warranty is given from the date of purchase. The warranty
is for free repair or replacement if cover manufacturing faults only.
For faults beyond the 3-year warranty, we reserve the right to
charge for time and parts.
2. Warranty exclusions below:
Any man-made damages caused from improper operation, or
connecting to excess voltage and overloading.
The product appears to have excessive physical damage.
Damage due to natural disasters and force majeure.
Warranty label, fragile label and unique barcode label have been
damaged.
The product has been replaced by a brand new product.
3.
4.
★ This manual only applies to this model. reserve the right to
make changes without prior notice.
We
Repair or replacement as provided under this warranty is the
exclusive remedy to the customer. We shall not be liable for any
incidental or consequential damages for breach of any stipulation
in this warranty.
Any amendment or adjustment to this warranty must be approved
in writing by our company only.
Update time：2017.07.10_A0
Before adding Motion sensor, please make sure App have
been installed and gateway have been set-up, more details
can be found on intelligent gateway manual.
Scan QR Code to download the APP via mobile phone.
Adding Devices Opening App firstly, press " " icon, on selector zone
click "Add intelligent devices", press "motion sensor"
on next interface.
Follow the tips, press configuration key (blue light flicker
slowly), meanwhile pressing re-set hole (indicator light
flicker), press "Match" on App. If the red light of motion
sensor slowly flicker 4 times then keep on for 1s,
matching successfully.
Finding motion sensor icon on App, click to enter and
begin intelligent control.
Click “Sensor trigger”, entering trigger lamp selection
of device or scene.
Click “Trigger period”, entering trigger period interface.
Click “Shutdown delay”, entering shutdown delay interface.