LTI LAL 1474 Series User manual

LAL 1474
Assembly Instructions
Form. LT013 – rev. 00 - 06/06/2017 page 1 of 3
 PARTS OF THE PRODUCT LAL 1474 2FT, 4FT AND 8FT:
 TOOLS REQUIRED:
01 BODY
02 DRIVER
03 LED CHASSIS
04 SCREW
05 LED BOARD
06 SCREW
07 PLASTIC LENS
Screws number 6 and 8
for LED board and for
assemble the metal parts.
7
Remember that yo
u should have some extra
accessories:
Wire for connection between LED boards and driver.
Suspension kit for install the fixture as a pendent or
screw for install as a surface fixture.

LAL 1474
Assembly Instructions
Form. LT013 – rev. 00 - 06/06/2017 page 2 of 3
 STEP BY STEP TO ASSEMBLE THE FIXTURE.
Always use UL certified products.
01 – Take the body and Install the suspension
kit. Screw the pins of the suspension on the
back of the body.
02 – Install the driver and the ground wire inside
of the body of the fixture.
03 – Connect the power cable plugging the
“strain relief” in the back of the body. After you
should make the AC and dimming connections.
04 – Fix the LED board into the LED chassis using
the screw number 06.
The fixture 2 and 4 FT have one LED chassis per fixture but
the 8 FT has 2 LED chassis per fixture.
05 – Make the connection between driver and
LED boards, use connectors UL approved.
Do not forget to follow the wire diagram that is
explained in the cut sheet of the product to make
the connections.
06 – Screw the LED chassis in the body.
Remember that the LED boards are already
connected with the driver and with the external
power cable.
In this case you will have two LED chassis in the fixture 8 FT,
however, for 2 and 4 FT fixture you have only one LED
chassis per unit.

LAL 1474
Assembly Instructions
Form. LT013 – rev. 00 - 06/06/2017 page 3 of 3
07 - Attach the Plastic Lens by hands and your
fixture is assembled.
Here again you will install two lenses 4 FT to make the 8 FT
fixture.
 CONTINUOUS RUN
You can connect more than one fixture making a continuous line of LAL 1474 fixture. You should use the
Joiner (part number 2380 17) to connect the fixture. In this case you have to screw the joiner and connect
the second fixture before the step number 06.
Open the knockout at the headboard of
the fixture to pass the cable. Make the
connections AC and dimming and use
four nuts per union to attach the joiner
to the headboard of the device by
joining the two pieces.