Lucid HLT-BT-H-PH Series User manual

Lucid Audio Amped Bluetooth®Headphones
(HLT-BT-H-PH Series)
These Amped Bluetooth®Headphones were engineered from the ground up with the goal of having the lowest
possible profile without compromising the hearing protection, amplification, and wireless sound properties of
the headphones. Delivering an impressive NRR of 21dB, the Amped Series Bluetooth®Headphones by Lucid
Audio are sure to enhance and protect your hearing, while allowing you to listen to music or take phone calls.
Power On:
-Short press the Bluetooth® Sync button to turn on the Bluetooth® feature (LED will flash every 1 second).
Power Off:
-Long press and hold the BT button for 3 seconds to turn off Bluetooth® device.
Pairing:
-Long press and hold the BT button for 1 second to enter pairing
mode after turn on (this will time out after 60-seconds).
-Open Bluetooth® wireless setting on your phone or mp3 player
-Make sure Bluetooth® is on and select “Lucid BT” to connect.
-Auto re-connect to previous last connected device during
pairing if the BT device has been paired previously.
-Once paired, blue LED will be flashing every 10 seconds.
Answer Call:
-Short press the BT button to answer incoming call.
Reject Call:
-Long press the BT button to reject the call.
Cancel/end call:
-Short press the BT button to cancel/end call.
Call on hold/waiting:
-During phone calls, if another new call is received, double
press the BT button to switch from the first call to second call.
-To switch back to first call, short press the BT button, which ends
the second call and it will be switched to previous call.
Last number redial:
-Double press the BT button to re-dial the last phone number.
Audio pause/play:
-Short press the BT button to pause/play music.
(TOLL-FREE CUSTOMER SUPPORT 800-775-7124)
www.lucidaudio.com
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. any use of such marks by Hearing Lab Technology, LLC is under license. Other
trademarks and trade names are those of their respective owner.
Volume
Control Knob
Bluetooth®
Volume Knob
Battery Compartment
Blueetooth Sync Button
Proper Fit:
-Place the headset over the head and secure the muff cups over each ear. Adjust the headband to ensure a secure fit.
CAUTION
- Do not mix old and new batteries.
- Do not mix Alkaline, Standard or Rechargeable batteries.
- Improper fit of this device will reduce its effectiveness in attenuating noise. Consult the enclosed instructions for proper fit.
NRR INFORMATION
Although hearing protectors can be recommended for protection against the harmful effects of impulsive noise, the Noise
Reduction Rating (NRR) is based on the attenuation of continous noise and may not be an accurate indicator of the
protection attainable against impulsive noise such as gunfire.
The level of noise entering a person's ear, when hearing protector is worn as directed, is closely approximated by the
difference between the A-weighted environmental noise level and the C-weighted environmental noise level.

FCC NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interference cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.
Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.
Table 3.1: Ear Muff NRR Calculation Worksheet
Table 3.2: Earbud Mean Attenuation Levels
Frequency 125 250 500 1000 2000 3150 4000 6300 8000
Mean Attenuation 7.1 16.0 27.4 37.1 42.1 44.6 43.8 31.7 27.2
Earbud Deviation 1.8 1.1 1.4 2.1 1.7 1.7 2.4 0.2 0.1
1/3 octave
centerband
frequency
Assumed or
Measured
Sound levels
exterior to
Earmuff
C-weighting
response
correction
C-weighted
Sound Levels
Exterior to Ear
Muff or Plug
A-weighting
response
correction
A-weighted
Sound Levels
Exterior to Ear
Muff or Plug
Un-weighted
Attenuated
Levels of Ear
Muff or Plug
Standard
Deviation of
Attenuation
Standard
Deviation of
Attenuation
TIMES 2
Estimated
Projected A-
weighted
Levels inside
Ear Muff or
Plug
125 99.2 -0.2 99.0 -16.1 83.1 7.1 1.8 3.6 79.6
250 92.8 0.0 92.8 -8.6 84.2 16.0 1.1 2.1 70.3
500 93.7 0.0 93.7 -3.2 90.5 27.4 1.4 2.9 65.9
1000 94.9 0.0 94.9 0.0 94.9 37.1 2.1 4.2 62.0
2000 96.1 -0.2 95.9 1.2 97.3 42.1 1.7 3.4 58.5
3150 95.8 -0.5 95.3 1.2 97.0 44.6 1.7
4000 94.6 -0.8 93.8 1.0 95.6 43.8 2.4 4.0 55.8
6300 78.2 -2.0 76.2 -0.1 78.1 31.7 0.2
8000 78.4 -3.0 75.4 -1.1 77.3 27.2 0.1 0.3 50.4
Overall C Level 104.0 Overall A Level 80.3
NRR Calc
Overall C Level 104.0
Overall A Level 80.3
NRR = 20.7

LIMITED WARRANTY
Lucid Audio warranties this product to the original purchaser to be free from defects in materials and workmanship, under normal
use and conditions for a period of one year parts from the date of purchase.
Under this warranty, this unit will be replaced or repaired at our option. Copy of the original receipt or gift receipt, is required for
any warranty service. To enact the warranty, the customer is required to contact our Customer Service Group at 800-775-7124 to
receive an Return Authorization (RA) number PRIOR to sending the product back.
This warranty is void if any of the following occur:
1. The unit is not accompanied by a copy of the receipt or gift receipt from the original purchaser.
2. The unit has been tampered with, opened or punctured.
3. The unit has been immersed in water or other liquids, allowed to be filled with dirt or dust, or otherwise physically abused.
4. The one year limited warranty has expired. Please inquire about other options from your Customer Service Representative.
This shall be the exclusive written warranty of the original purchaser and neither this warranty nor any other warranty, expressed or
implied, shall extend beyond the 12-month period listed above. In no event shall Lucid Audio be liable for consequential property
damage, or consequential personal injury. (Some states do not allow limitations on implied warranties or exclusions of
consequential damages, so that these restrictions may not apply to you). This warranty gives you specific legal rights, and you may
have other rights, which vary from state to state.
Record Serial # for future reference:
Please return this bottom portion to Hearing Lab Technology, LLC. –PO Box 535596 –Grand Prairie, TX 75053-5596
Warranty Registration
Model: Date of Purchase:
Purchased From
City: State: Zip:
Primary Use:
Your Name:
Address:
City: State: Zip:
Email Address: Serial #: