EDIFIER TWS2 Quick start guide

Truly Wireless Stereo Earbuds
TWS2

■ Product Description and Accessories
1
There are different sizes of earmuffs attached in the package, please
select the suitable ones to wear.
LED light
Multifunctional button
Charging cable
Charging case Earmuffs x 3

■ Operational Guide
2
● Headphones Charging
During using if only red light flashes, it indicates the headphones are at
low battery level, please use them after fully charged.
Charging: place the headphones into the charging case, and note left
and right matching.
Charging time: about 1.5 hours for a full charging
LED light: red light steady lit = charging
blue light steady lit = fully charged
Warning:
The rechargeable batteries that provide power for this product must
be disposed properly for recycling. Do not dispose of batteries in fire to
prevent an explosion.
● Charging Case Charging
Only the leftmost white light flashing = low battery level, please charge
the case in time
Three white lights all lit = fully charged, now the case can charge
headphones three times

3
● Power ON/OFF
1. Power ON
•Take headphones out from the charging case, they will turn on
automatically;
•When without the charging case, press and hold the multifunctional
button for 5 seconds to turn the headphones on.
2. Power OFF
• Place headphones into the charging case, they will turn off automatically;
• When without the charging case, press and hold the multifunctional
button for 5 seconds to turn the headphones off.
● Bluetooth Connection
1. Two Headphones Mode
•Open the charging case to take two headphones out, they will
automatically turn on, make interconnection, and enter pairing state
with the red & blue lights flashing rapidly;
•Set the mobile phone to search for and connect to “EDIFIER TWS2”,
after pairing is successful, the blue light will flash slowly.
2. One Headphone Mode
•Take the left or right headphone out from the charging case, it will
turn on automatically;
•Press and hold the multifunctional button to let the headphone enter
pairing state with red & blue lights flashing rapidly;
•Set the mobile phone to search for and connect to “EDIFIER TWS2”;
after the pairing is successful, the blue light will flash slowly.

4
● TWS Pairing and Connection of the Left and Right
Headphones
The left and right headphones have finished TWS pairing before leaving
the factory. If the wireless connection fails to resume, please follow the
steps below to re-pair:
• Under standby and there is no Bluetooth connection, separately double
press the multifunctional button of the left and right headphone to
enter TWS pairing state, the blue light will flash rapidly; (If the left/
right headphone has been connected to Bluetooth of one mobile
phone, please firstly disconnect Bluetooth and then double press the
multifunctional button to enter TWS pairing.);
•After the pairing is done, the blue lights of both headphones will
flash slowly.

● Music Playback Mode
● Call Mode
■ Functional Operation Instructions
5
Note: Enabling voice assistant function may not be supported by some Android
devices due to system settings.
Previous track: double press the left headphone
(disabled for One Headphone Mode)
Next track: double press the right headphone
(disabled for One Headphone Mode)
Pause playing: press once
Resume playing: press once
Answer incoming call: press once
Reject incoming call: press and hold
Hang up call: press once
Voice assistant: press three times

Red light instead of blue light ashes.
•It indicates the headphones are at low battery level, please recharge
the headphones.
Red light is o during charging.
• Ensure the headphones are appropriately placed in the charging case.
•When the headphones are not used for long periods of time, the
battery will enter sleep state, it needs to charge about 30 minutes
and then the red light will be lit.
No sound
•Check if the headphones are operating.
•Check if the headphones volume is at an appropriate level.
•Check if the headphones are correctly connected with mobile phone.
• Check if the headphones are operating within a normal working range.
Call eect of the headphones is bad.
•Check if mobile phone is in an area with strong signal.
•Ensure the headphones are within effective distance (10m) and no
obstacle between the headphones and mobile phone.
When playing music, can not control pause/play/previous track/
next track via headphones.
•Ensure the paired device support AVRCP (Audio/Video Remote
Control Profile) profile.
■ FAQs
6

During using, please read the following advices carefully.
•Keep the product away from humid places to avoid affecting internal
circuit. Do not use the product during intense exercise or with much
sweat to prevent sweat from dropping into it to make damage.
•Do not put the product in places exposed to sun or with high
temperature. High temperature will shorten service life of electronic
components, damage battery and deform plastic components.
•Do not put the product in cold places to avoid damaging internal
circuit board.
•Do not dismantle the product. Non-professional personnel may
damage the product.
• Do not drop, strongly vibrate, strike the product with hard object to
avoid damaging internal circuit.
•Do not use drastic chemicals or cleaner to clean the product.
• Do not use sharp objects to scratch product surface to avoid damaging
shell and affecting looking.
If the product cannot operate properly, please send it to your qualified
maintenance agency.
■ Maintenance
7

Correct Disposal of this product. This marking indicates that this product
should not be disposed with other household disposal, recycle it
responsibly to promote the sustainable reuse of material resources.
To return your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take
this product for environmental safe recycling.
•“To prevent possible hearing damage, do not listen at high volume
levels for long periods.”
•“Fully understand user manual before use.”
•“Ensure your player at low volume levels or power off before you
leaving.”
CAUTION
8
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
A warning that batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.

9
WARNING!
Danger of explosion if the battery is incorrectly replaced. Replace only
with the same or equivalent type.
For products with removable battery, the battery must be properly
recycled or disposed. For products with built-in battery, disassembling
is prohibited.
Never disassemble, hit with force, squeeze batteries or dispose of
batteries in fire. Do not expose batteries in conductive materials, liquid,
fire or heat. Do not let metal object contact two battery poles. If the
battery looks swollen, leaking, discolored, having odor or any
abnormal appearance, stop using it. Do not use the battery after
immersed in water.
Improper use of battery may lead to explosion or leakage, causing skin
burn or other injuries; in the event of battery leakage, handle it with
care and immediately dispose of the battery in the manner in
compliance with applicable laws and regulations in your locality.
FCC statement:
“This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.”
IC statement: CAN ICES-3(B)/NMB-3(B).
FCC ID: Z9G-EDF80 IC: 10004A-EDF80