Lumens OIP-AC01 User manual

www.MyLumens.com
Copyright © 2021 Lumens Digital Optics Inc. All rights reserved.
5100462-50 SEP. 2021
OIP-AC01 Quick Installation Guide
1. PACKAGE CONTENTS
6U Rack Chassis
Installation Guide
Power Adapter
Power Connector
M5 Screw x8
Cable Clip x5
(Appearance may vary
depending on country/region
2. Power & System Requirements
Power Requirement: DC 12V, 3Apower supply for the cooling fan system.
System Requirement:
The 6U rack chassis requires a minimum of 266.7mm (10.5in) contiguous
free space in the rack for mounting.
With the Cooling Fan System installed, an additional 1U space above the
chassis should be left empty to provide space for air to flow freely.
3. Installation Instructions
STEP 1
Install the OIP-AC01 to the rack with M5 Screws*8pcs.
STEP 2
Unscrew the 3 thumbscrews holding the top locking panel in place, and remove
the panel from the front of the chassis. Unscrew the 3 thumbscrews holding the
bottom locking panel in place, and remove the panel from the front of the
chassis.
Note: The thumbscrews are connected to the locking panels with a retentionmechanism
and will not come completely free when they have been unscrewed from the chassis.

www.MyLumens.com
Copyright © 2021 Lumens Digital Optics Inc. All rights reserved.
STEP 3
Align and then carefully slide a full or half-length compatible audio/video unit into
the top/bottom grooves of a free slot. Half-length units are designed with a notch
to prevent them from sliding all the way to the back of the rack chassis. Repeat
this step until all units have been installed.
Note: If fewer than 15 units are being mounted it is strongly suggested toleave empty
space between units that get particularly warm to improve airflow and heat dissipation.
STEP 4
Reattach the top and bottom locking panels by screwing in the 3 thumbscrews on each
until they are tight and secure.
Note: Be careful to not overtighten the thumbscrews as this could damagethe screw
threads.
STEP 5
Connect DC 12V, 3A power supply to the cooling fan system