Luminar Outdoor 59269 Assembly instructions

Visit our website at: http://www.harborfreight.com
Email our technical support at: [email protected]
Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly,
operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back
of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep
this manual and the receipt in a safe and dry place for future reference. 21l
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-888-866-5797 as soon as possible.
Copyright©2021 by Harbor Freight Tools®. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein.
Tools required for assembly and service may not be included.
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.

Page 2 For technical questions, please call 1-888-866-5797. Item 59269
SPECIFICATIONS
Battery Type AA NiCd 1.2V 400mAh
Charge Time 6 - 8 hr.
Run Time 8 hr.
Solar Cells Amorphous Silicon
IMPORTANT SAFETY
INFORMATION
1. Assemble only according to these
instructions. Improper assembly
can create hazards.
2. Wear ANSI-approved
safety goggles during setup.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the
area during assembly.
5. Do not assemble when tired
or when under the influence
of drugs or medication.
6. Position battery in proper polarity and
do not install batteries of different types,
charge levels, or capacities together.
7. This product is not a toy. Do not allow
children to play with or near this item.
8. Use as intended only.
9. Inspect before every use; do not use
if parts are loose or damaged.
10. Maintain product labels and
nameplates. These carry
important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
SETUP INSTRUCTIONS
11. Push the Switch on the back of
the Housing towards ON.
12. Decide where you want to place
the Solar Light. Choose a location
that receives full, direct sunlight
a minimum of eight hours a day.
The location should not be near
nighttime light sources such as
porch lights or streetlights as this will
cause the Solar Light to remain off.
13. Make certain that the path of the Stake
is clear of lines, cables and conduits.
14. With a rubber mallet, gently tap
the Stake into the ground.
15. Once the Stake is securely in the
ground, slip the Solar Light Pole
onto the top of the Stake.
16. Slide the flat part of the Connector into
the bracket on the back of the Housing.
17. Place the round part of the Connector
onto the top of the Pole.
18. Place the Lights nearby as desired.
CAUTION! Do not place the Lights
where they will create a tripping hazard.

Page 3For technical questions, please call 1-888-866-5797.Item 59269
OPERATING
INSTRUCTIONS
Note: During the day, the Solar Panel
converts sunlight into electricity, recharging
the battery. The amount of light the Solar
Panel receives depends on placement of the
Solar Light, geographic location and weather.
If the weather is cloudy and the panels do
not receive a full charge, the Solar Lights
may not achieve the full run time. They will
catch up after two to three days of full sun.
1. After a full 6-8 hours of sunlight
charging, the Lights will automatically
turn ON during the night.
2. After the initial charge is set, check to
see that the Lights are on by viewing
them at night or in a dark location.
If they are not lit, check that the
Switch is ON and the Solar Panel
has had full sunlight for 8 hours.
MAINTENANCE
3. Clean regularly with a damp towel.
Do not clean with solvent.
Do not put too much pressure on
the Solar Panel or accessories
while cleaning. Dry thoroughly.
4. BEFORE EACH USE, inspect the
general condition of the tool. Check for:
• leaking, swollen, or cracked battery,
• loose hardware,
• misalignment or binding of parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
5. AFTER USE, wipe external surfaces
of the tool with clean cloth.
6. NiCd BATTERY MUST BE RECYCLED
OR DISPOSED OF PROPERLY.
Do not short, incinerate or
open battery. To remove battery:
Remove the four screws
holding the housing together.
Using a small flat head screwdriver,
carefully pry the housing apart around
its perimeter to break the seal.
Remove the battery.
Note: Opening the housing will reduce
the water resistance of this product.
Troubleshooting
Problem Possible Causes Probable Solutions
Light will
not turn on
1. Switch is set to OFF.
2. Battery not allowed time for
recharging via Solar Panel.
3. Solar Light is set near
nighttime light sources such as
porch lights or street lights.
4. Solar Panel is dirty and
covered with dirt or dust.
1. Turn Switch on.
2. Check that Solar Panel has direct
access to sunlight. Allow one to
two days for a full charge.
3. Move Solar Light or change Solar Panel
position.
4. Clean Solar Panel with a soft cloth.

Record Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Replacement parts are not available for this item. Reference UPC 193175464170.
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality
and durability standards, and warrants to the original purchaser that this product is free from
defects in materials and workmanship for the period of 90 days from the date of purchase.
This warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence
or accidents, repairs or alterations outside our facilities, criminal activity, improper installation,
normal wear and tear, or to lack of maintenance. We shall in no event be liable for death,
injuries to persons or property, or for incidental, contingent, special or consequential damages
arising from the use of our product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation of exclusion may not apply to you.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with transportation
charges prepaid. Proof of purchase date and an explanation of the complaint must accompany
the merchandise. If our inspection verifies the defect, we will either repair or replace
the product at our election or we may elect to refund the purchase price if we cannot readily
and quickly provide you with a replacement. We will return repaired products at our expense,
but if we determine there is no defect, or that the defect resulted from causes not within
the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state.
26677 Agoura Road • Calabasas, CA 91302 • 1-888-866-5797