Lux Blox Sea Adventure Yellow Submarine User manual

ir u_i lu
u
Sea Adventure
Yellow Submarine
INSTRUCTIONS
241
10 black squares 2 trigon wheels
180 yellow squares 4 square wheels
10 black trigons 6 #2 small axles
25 yellow trigons 4 #7 large axles
For more information go to www.luxblox.com

Constructing the Main Submarine
Periscope
Conning Tower
Mini Submarine Bay
Hull
Propeller
Aft Hydroplane
Forward Hydroplane
Snap together the main hull conguration on a at
surface

Decompression chamber
bulkhead
Snap together the decompression chamber bulkhead so the dimples are facing
out. This will permit the bulkhead to attach to the opening in the hull

Attach decompression chamber
Fold main hull and attach to decom-
pression chamber and forward and aft
bulkheads

Front view of main hull Rear view of main hull
Lay out the conning tower part with the dimples facing up and then attach the
conning tower sections to the rectangualr opening on the top of the hull
Top of tower

Conning tower
assembly
Top of tower
Attach the top of the
conning tower starting
at the back and going
to the front, as shown.

Aft bulkhead assembly
Pre-assemble the aft
bulkeads as shown
with the dimples facing
up and then fold them
up into cubes
Attach the aft bulkheads
to the main submarine
hull as shown
Aft bulkheads

Pre-assemble the parts of the
propellers and aft
hydroplanes
The aft hydro planes also
act as rudders and should
be free to move from side to
side
The propeller’s gears should
mesh together and move each
other
Insert the #7 long axles so the three
keys and three spaces are exposed Slide two large wheels over the axles
until they are nestled against the face of
the aft bulkhead
Assemble the three-square spacer
Slide the space bar onto the two shafts until
they are against the forward propellers
Assemble the rear propellers Slide on the rear propellers until they
are against the three-square spacer
Assemble the aft hydroplane
and insert onto the shafts

Pre-assemble the mini submarine bay by laying
it at with dimples facing up
Flip the main sub and attach the bottom of the mini
submarine bay to the botttom of the main submarine
Attach the top of the mini
submarine bay to the top
two remaining sections of
the main submarine forward
bulkhead
Attach the forward hydroplanes to the rectangular openings on the port (left) and starboard (right)
sides of the bay (repeat steps on both sides of submarine)
Forward hydroplane

Making the mini submarine
Hull
Conning tower
Aft bulkhead and
propellers
Propellers and aft bulkhead
Conning tower
Hull
Starboard bay
attachment arm Starboard robotic arm
attachment