LuxCraft 2' Adirondack Poly Glider User manual

Inch
0
1
2
3
4
5
6
7
2' Adirondack Poly Glider Assembly Instructions
1 - (A) Seat Assembly
1 - (B) Back Assembly
1 - (C) Glider Base right side
1 - (D) Glider Base left side
2 - (E) Front & Back Cross Pcs.
2 - (F) Lintels
2 - (G) Bearing Support Arms
2 - (H) Armrest Assemblies
Hardware
2 - 5/16" x 3 1/2" Stainless Wafer Bolt
2 - 5/16" x 2 1/2" Stainless Wafer Bolt
4 - 5/16" x 2" Stainless Wafer Bolt
4 - 3/8" Nuts
4 - Washers
44 - 2" Screws
1 - 5/32 Hex Key
1. Attach (E) Front Cross Pc. to Glider Base
Sides using 7 - 2" Screws per Side, Be sure to
match all numbers
& or letters.
2. Attach (E) Back Cross Pc. to Glider Base
Sides using 7 - 2" Screws per side, Be sure
to match all numbers & letters.
3. Attach (G) Bearing Support Arms to Glider
Base using 4 - 2" Screws per side, Be sure to
match all numbers & or letters.
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)

Inch
0
1
2
3
4
5
6
7
Washer
Nut
Armrest Assembly
2 1/2" Wafer Bolt
3 1/2" Wafer Bolt
2" Wafer Bolt
4. Attach (H) Armrest Assemblies to
sides of Glider Base using 2 - Washers
& 2 Nuts per side, Be sure to match all
numbers & or letters.
5. Attach (B) Back Assembly to
(A) Seat Assembly using 1 - 2"
Wafer Bolt in top hole per side, Be
sure to match all numbers & or letters.
Tighten Wafer Bolts with included
Hex Key.
6. Slide Seat & Back Assembly between
Armrest's & install 1 - 3 1/2" Wafer Bolt
1 - 2 1/2" Wafer Bolt & 1 - 2" Wafer
Bolt per side, Be sure to match all numbers
& or letters, Tighten Wafer Bolts with
included Hex Key.
7. Attach Lintels to Armrest Assemblies
using 4 - 2" Screws per side, Be sure to match
all numbers & or letters.