2' Classic and
2' Hummingbird Glider
Assembly Instructions
Base Parts List
2- End Piece Assembly
2- Leg Assembly
4- Glider Arms with
Bearing & Bolt Assembly
1- Center Cross Piece -
2" x 3" x 17⁄"
1- Center Cross Piece -
2" x 3" x 20⁄"
6- ⁄" x 4⁄" Bolts
4- ⁄" x 4" Bolts
2- ⁄" x 3⁄" Bolts
4- ⁄" x 3" Bolts
8- 2⁄" Screws
16- ⁄" Nuts
16- Washers
Hardware List
INSTRUCTIONS: *Always match numbers/letters printed on each individual piece. (1 to 1, 2 to 2, A to A, B to B, etc.)
Step 1 - To assemble
glider base, attach
center cross pieces
(2" x 3" x 20⁄" and
2" x 3" x 17⁄") to
end piece assembly.
*Match numbers. Put
four 4⁄" bolts in top
and four 4" bolts in
bottom. Secure with
washers and nuts. Step 2 - Remove one
washer and nut from
each end of glider
arm assembly. Attach
one end of glider arm
assembly to each
pre-drilled hole in end
piece assembly. Fasten
with washer and nut.
Assembled bottom
base ready for leg and
glider arm assemblies.
0 1 2 3 4 5 6 7
INCH
continued on back
