Luxlink ACC-1005 User manual

OPERATING INSTRUCTIONS
Model ACC-1005
30dB RF Power
Amplifier
The LuxLink®Model ACC-1005 is an RF Power amplifier with a
nominal power gain of 30 dB. It is designed to amplify the output of a
fiber optic receiver when driving low impedance 50 ohms loads in a
wide variety of applications.
Technical Specifications
Bandwidth 1MHz to 150 MHz (-3dB)
Power Gain 30dB typical
In/out Impedance 50 ohms
Typical Input Level +4dBm (0.35V rms)
Maximum Input** +10dBm (0.7V rms)
Maximum Output +30 dBm (50 ohms)
Operating Power +18 to +24 VDC @ 0.5A typical
Temperature range 0 to 50 degrees, C
All specifications are subject to change without prior notice.
** Do not apply more than +10dBm to the input or damage may
occur.
This unit is designed to operate into a 50 ohm load. To avoid
damage do not apply an input signal to the amplifier with the output
load disconnected.
When operating at full power output the ACC-1005 will get warm. Be
certain to allow adequate air circulation around the integral heat sink.
OPERATING INSTRUCTIONS
Model ACC-1005
30dB RF Power
Amplifier
The LuxLink®Model ACC-1005 is an RF Power amplifier with a
nominal power gain of 30 dB. It is designed to amplify the output of a
fiber optic receiver when driving low impedance 50 ohms loads in a
wide variety of applications.
Technical Specifications
Bandwidth 1MHz to 150 MHz (-3dB)
Power Gain 30dB typical
In/out Impedance 50 ohms
Typical Input Level +4dBm (0.35V rms)
Maximum Input** +10dBm (0.7V rms)
Maximum Output +30 dBm (50 ohms)
Operating Power +18 to +24 VDC @ 0.5A typical
Temperature range 0 to 50 degrees, C
All specifications are subject to change without prior notice.
** Do not apply more than +10dBm to the input or damage may
occur.
This unit is designed to operate into a 50 ohm load. To avoid
damage do not apply an input signal to the amplifier with the output
load disconnected.
When operating at full power output the ACC-1005 will get warm. Be
certain to allow adequate air circulation around the integral heat sink.

WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and its subsidiaries are fully tested prior to
shipment and are warranted against defective materials and workmanship
for a period of five full years from the date of the original shipment.
Should a problem occur, a Return Material Authorization Number
(RMA) must be obtained from Liteway Inc. at [phone] and the
item returned to Liteway, Inc. 166 Haverford Road, Hicksville, NY
11801, USA, prepaid. Liteway Inc. will then, at its option repair or
replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the cost
of the defective item only. No contingent liabilities of any kind are either
assumed or implied.
Any items returned to Liteway, Inc. that have been misused, abused,
damaged, modified, connected or adjusted in any way contrary to the
instructions furnished by Liteway, Inc. or repaired by unauthorized
personnel will not be covered by this warranty. Any non-warranty
repairs required will be quoted at the current rate for such services.
Important Notices
CAUTION ! AVOID DIRECT EXPOSURE TO BEAM.
All -7,-8, and -9 Models use laser diodes. These solid-state laser diodes
are located in the optical ports of these units. Laser diodes produce
invisible radiation that may be harmful to human eyes. Never look
directly into the optical port of any fiber optic unit designed to operate
with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications of any
kind.
© Copyright 2017 Liteway, Inc. 136012 Rev F
WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and its subsidiaries are fully tested prior to
shipment and are warranted against defective materials and workmanship
for a period of five full years from the date of the original shipment.
Should a problem occur, a Return Material Authorization Number
(RMA) must be obtained from Liteway Inc. at [phone] and the
item returned to Liteway, Inc. 166 Haverford Road, Hicksville, NY
11801, USA, prepaid. Liteway Inc. will then, at its option repair or
replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the cost
of the defective item only. No contingent liabilities of any kind are either
assumed or implied.
Any items returned to Liteway, Inc. that have been misused, abused,
damaged, modified, connected or adjusted in any way contrary to the
instructions furnished by Liteway, Inc. or repaired by unauthorized
personnel will not be covered by this warranty. Any non-warranty
repairs required will be quoted at the current rate for such services.
Important Notices
CAUTION ! AVOID DIRECT EXPOSURE TO BEAM.
All -7,-8, and -9 Models use laser diodes. These solid-state laser diodes
are located in the optical ports of these units. Laser diodes produce
invisible radiation that may be harmful to human eyes. Never look
directly into the optical port of any fiber optic unit designed to operate
with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications of any
kind.
© Copyright 2017 Liteway, Inc. 136012 Rev F
!!