Lynx A1200 User manual

OWNERS MANUAL
A1200
A1201
dustlesstools.com

SAVE THESE INSTRUCTIONS CONSERVER CES INSTRUCTIONS GUARDAR ESTA INSTRUCTIONES
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANTES MESURES DE SECURITE IMPORTANTE PARA SU SEGURIDAD
NOTE: The reading and understanding of the Owner’s Manual is imperative prior to operating this machine. If you or your operator(s)
cannot read English, have this manual explained fully before attempting to operate this machine. Si Ud. o sus operadores no pueden
leer el inglés, el contenido completo de este manual será explicado antes de intentar operacion de esta máquina.
Read the Owner’s Manual completely before
attempting to operate this unit. Failure to follow the
warnings and instructions may result in burns, fire,
electric shock, or personal injury:
WORK AREA SAFETY
• Do not operate the vacuum in explosive atmospheres.
Sparks from static electricity or the motor may ignite dust
or fumes.
ELECTRICAL SAFETY
• Connect to a properly grounded outlet. See grounding
instructions.
• Always unplug unit when not in use and before servicing.
• Electrical components are not user serviceable. Refer all
service to a qualified repair technician.
• Do not handle the plug or operate the vacuum with wet
hands.
PERSONAL SAFETY
• Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
• Do not change the filters, clean the unit, or empty the
tank until the plug has been disconnected from the
electrical outlet.
• Use special care when emptying heavily loaded canisters.
• Keep hair, loose clothing, fingers, and all parts of body
away from openings and moving parts. There is a risk of
injury through getting stuck or being drawn into moving
machinery.
• Use extra care when working on stairs.
• Injury to the eyes and/or body can occur if protective
clothing and/or equipment is not worn. Always wear
safety goggles, protective clothing, hearing protection,
and a dust mask. Exposure to high noise levels can
cause hearing loss or impairment. Wear OSHA-approved
hearing protection when using this vacuum.
TOOL USE AND CARE
• Always check the filter before each use. Do not use
without the filter in place.
• Do not use with damaged cord or plug.
• Do not use if the vacuum is not working normally.
• Do not expose the vacuum to excessive heat, as damage
to the vacuum may occur and the warranty will be null
and void.
• Do not pull or carry by the cord, use the cord as a handle,
close a door on the cord, or pull the cord around sharp
edges or corners. Do not run the vacuum over the cord.
Keep the cord away from heated surfaces.
• Do not unplug by pulling on the cord. To unplug, grasp
the plug, not the cord
• Turn off all controls before unplugging.
• Changes, add-ons, or conversions of the vacuum which
might have an influence to the safety of the vacuum
must not be undertaken without the permission of the
manufacturer. This applies in particular to the fitting and
adjustment of safety devices and to the welding on major
and load bearing parts.
• Spare parts must always comply with the technical
requirements and the specifications of the manufacturer.
This is always guaranteed with original spare parts from
the manufacturer.
• In the event of operational malfunctions, the vacuum
must be shut down immediately. The malfunction must be
corrected before starting the vacuum again!
SERVICE
• Adjustments, servicing, inspection work, and inspection
intervals specified in these Operating Instructions, as
well as any information on the replacement of parts
and systems of the vacuum, must be undertaken and
complied with.
• These activities can only be undertaken by qualified
personnel.
• Make sure that electrical components used for
replacement purposes comply with the original parts and
are correctly adjusted if necessary.
• Before performing any maintenance, place the vacuum
in the safety off position, which is the position of the
vacuum when it cannot generate any hazard.
SPECIFIC SAFETY RULES
• Do not allow this unit to be used for anything other than
ash removal.
• Do not store this unit immediately after ash removal in
any enclosed or confined area.
• Do not vacuum burning/live material i.e. PELLETS.
• Do not use to pick up flammable or combustible liquids,
such as gasoline.
• Use of accessories not recommended by the
manufacturer may cause fire, electric shock, or injury.
• Please handle in accordance with the regulation of how to
dispose of the ash so that you meet the requirements of
local regulations.
• Do not use outdoors or on wet surfaces.
• Do not leave appliance when plugged. Unplug from
outlet when not in use and before servicing. Do not use if
appliance has been dropped, damaged, left outdoors, or
exposed to water.
• WARNING – Fire hazard – Intended for vacuuming
cold to warm ashes only. General household or shop-vac
use could increase fire risk by induction of combustibles
into unit prior to vacuuming ashes. Consult operating
manual before use.
DOUBLE-INSULATED INSTRUCTIONS:
WARNING - To reduce the risk of electric shock, this vacuum cleaner has a polarized plug (one blade is wider than the
other.) This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install the proper outlet: do not change the plug in any way.
If the opening that sucks in the air or the suction pipe is blocked, switch off the vacuum cleaner at once and clear the block-
age before you attempt to start the vacuum cleaner again.
Special NOTE: This vacuum’s motor is equipped with thermal overheat protection. If the motor runs too hot, it will shut
down. You must wait for the motor to cool in order to re-start vacuum. Cleaning the filter will help prevent a repeat of this
condition.

3
Customer Service Helpline 1.800.568.3949 dustlesstools.com
IN THE BOX
Port
Lid
Pellet Hose
Horse Hair Brush
Crevice Tool
Adaptor
Cap Hose
Canister
Spark Arrestor
HEPA Filter
SETUP
1. Remove entire contents of box.
2. Check that HEPA filter and spark arrestor
are installed to underside of lid. (Refer to
Filter and Spark Arrestor Installation)
3. Snap lid in place on empty canister.
4. Install hose in port.
5. Install accessories on lid.
FILTER AND SPARK ARRESTOR
INSTALLATION:
1. Insert HEPA filter into spark arrestor.
2. Install HEPA filter and spark arrestor to
underside of lid. Twist clockwise ensuring
all three latches “lock” into place.
Note: When reinstalling filter, visually inspect that
all three tabs are locked in place.
Manual
Nozzle
USAGE
TO REMOVE ASH:
1. Before vacuuming, move large pieces of
debris to the side.
2. Place the crimped end of the metal nozzle
directly on the bottom of the hearth.
3. Turn on the vacuum.
4. Keep the metal nozzle at a 45-degree
angle on the bottom of the hearth.
5. Rub the metal nozzle in a circular motion
on the bottom of the hearth to vacuum
ash.
45˚

4OM056_0913
MAINTANACE
FAQ
WARRANTY
Before Each Use
1. Check that HEPA Filter and Spark
Arrestor are in place and no holes are
present.
2. Place hose in port.
Seasonally: Replace HEPA Filter
6. VACUUM ONLY FINE ASH PARTICLES.
TO CLEAN FILTER:
1. Turn off the vacuum.
2. Keep the lid closed on the canister, do
not remove the lid.
3. Lift and release the Instant Filter Cleaning
Handle quickly 5 times to remove ash
from the HEPA filter.
ADAPTOR:
Connects your hose or metal nozzle to each
of the LYNX accessories. Slips on and off
easily - no tools needed.
HORSE HAIR BRUSH:
Use the brush to clean bricks, glass and
decorative logs.
PELLET STOVE CLEANING HOSE:
Use the hose to get inside small vents.
CREVICE TOOL:
Use the crevice tool to clean tight corners.
QUESTION ANSWER
How do I avoid
clogging the
nozzle?
Be sure the nozzle is not in
backward. Put the large end
in the hose and the crimped
end out.
Place nozzle directly on
firebrick and rub to move the
large particles out of the way,
maintain air flow and to crush
larger particles.
Why is dust
escaping?
Check filter for holes and
replace if necessary.
Check that all 3 tabs on spark
arrester are locked in place.
Why is the hose
hot?
Cleaning ash that is TOO
WARM. NEVER use gloves to
compensate for a HOT hose.
Why is there
poor suction?
Clean HEPA Filter. Turn off
vacuum and quickly snap
Instant Filter Cleaning Handle
5 times
THREE-YEAR LIMITED WARRANTY
At Dustless Technologies, we stand behind
what we build. We warranty this product to
the original retail purchaser against defects
in materials or workmanship for a period of
three years after date of purchase.
This limited warranty does not cover
claims resulting from: (I) misuse (II) neglect
(III) modification (IV) failure to follow
instructions.
WARRANTY CARD
Please register your product online at
www.dustlesstools.com within 90 days of
purchase.
WARRANTY CLAIMS
For warranty or returns on any of our
products, please contact your place of
purchase. Technical support is available at
[phone] or [e-mail].
5x