LYNXTechnik yellobrik DVD 1817 User manual

Technical Specications
Input Present
1
2
3
IN
4
5
6
7
3Gbit
SDI Reclocking Distribution Amplifier
USB
PC Control
Power
0V
12V
⎓
+–
DVD 1817
3G 1>7 SDI Reclocking Distribution Amplier
SDI Input
Present LED
DC Power
Input
SDI
Input
SDI Input 1 x SDI; 75 Ohm BNC connector
SMPTE 424M, SMPTE 292M, SMPTE 259M
Multi-standard operation from 270Mbit/s to 3Gbit/s; reclocking
Input present LED indication
Electrical Return Loss:
>15dB from 5MHz to 1.5GHz, >10dB from 1.5GHz to 3GHz
Automatic cable EQ
320m @ 270Mbit/s, 200m @ 1.5Gbit/s, 150m @ 3Gbit/s;
SDI Outputs 7 x multi-rate reclocked SDI outputs ; 75 Ohm BNC connectors
SMPTE 424M, SMPTE 292M, SMPTE 259M
Electrical Return Loss:
>15dB from 5MHz to 1.5GHz, >10dB from 1.5GHz to 3GHz
Alignment Jitter:
< 0.2 UI @ 270Mbit/s, < 0.2 UI @ 1.5Gbit/s, < 0.3 UI @ 3Gbit/s
Power +12V DC @ 2.7W nominal - ( supports 7 - 24V DC input range )
Physical Size: 138mm x 90mm x 22mm (5.43” x 3.54” x 0.86”) including
connectors
Weight: 240g (8.46oz)
We are constantly adding more yellobrik modules.
Please visit our website for the latest product updates.
www.lynx-technik.com
SDI Outputs
Power LED
USB Port
yellobrik
®
Quick
Reference
yellobrik
®
LYNX
Technik
AG
| Broadcast Television Equipment

Connections
All connections are clearly indicated on the module and self
explanatory. The I/O impedance is 75 Ohm.
Operation
The DVD 1817 has one multi-format SDI channel, with seven SDI
outputs. Dierent SDI video formats and standards (3G, 1.5G and 270M)
can be transmitted and received. The “Signal Present” LED (one per
input) is illuminated when a valid input signal is connected.
Operation is fully automatic. The SDI input rates are automatically detec-
ted, reclocked and provided on the SDI output connectors. No user set-
tings are provided for this module. The module supports hot swapping
and hot plugging of connections.
Power
The module requires a 12V DC power input and the LED conrms when
power is connected. A power supply is provided, however if you use
your own power supply, please provide a clean power source between
7 and 24V DC. Power consumption information can be found in the
technical specications table.
Power Lead Strain Relief
The module (dierent module shown here) has a small hole in the case
which is located above the power connection. Use the supplied tie-
wrap and secure the lead as shown below. This prevents the power lead
being accidentally pulled out.
Optional Mounting Solutions
The optional RFR 1001 mounting bracket can be used to permanently
mount the module on any surface or on 19” rack rails.
The optional RFR 1000-1 rack mount can be used to permanently
mount up to 14 yellobrik modules. In addition, the RFR 1000-1 can
provide full power redundancy for all mounted yellobriks.