The evaporative air cooler has the special advantages:
1. 3 speed for the wind
2. The thicker and bigger cooling pad for better heat absorption.
3. Wheel footing is easy moving.
4. There is a water inlet valve. When without water, there will be alarm.
5. Big capacity for the water tank, no need to add water frequently.
6. Removable cooling pad is easy for clean.
IMPORTANT REMINDERS
Please read the manual carefully before operating the cooler.
A) Operating conditions:
1- Temperature: 18℃to 45℃; Water Temperature: < 45℃.
2- Power supply must not exceed the required voltage (+/-) 5%.
3- Air supply must be largely free of dust or extra cleaning is required.
B) Protect the power cable from vehicle or foot traffic. Connection to incorrect
electric voltage, or faulty installation, will cause danger of electric shock.
C) If the product malfunctions at startup, please disconnect from electric power
immediately and refer to dealer for service.
D) Necessary caution measure including grounding
1- Keep doors and windows open to allow fresh air to enter, and treated air to exit,
when cooler is operating.
2- Flashing red light on the control panel means water level in reservoir is low.
3- Rinse the reservoir with fresh water and clean prior to use after a period where the
cooler has not been in operation.
4- Take care when moving the cooler, especially when it is full of water. Pushing too
hard will cause the cooler to overbalance and tip over, which may cause injury and
will damage the cooler.
5- Simplified description of the cooler installation process and the connection modes
to supply main of water and electricity
A- Open the carton, make sure the cooling machine is in good looking, put water
In the water tank, put plug on, power supply is 220-240V/50Hz including
grounding
-No lubricating process for there is no belt
B -Clean the water reservoir and change water in the reservoir each month
- Make sure the power is off, open the cooling pad, wash pad and water tank in
clean water each month.
CLEAN AND PROTECTION
1. AIR FILTER
Switch off the power and take away the plug, pull out the handle for the filter. Then
you can use the cleaner to wash it.
2. Outside the machine
Clean with the dry-wet cloth
3. Wet curtain
