
USAGE INSTRUCTIONS
To begin, set the desired Temperature Dial setting on the Rheostat at (40-50% power) approximate
midpoint.
Plug into your desired power source (A/C Wall Plug or Car Adapter), then plug into the Barrel Receiver.
Attach Magnetic Connection Cord to the 4-Pin Connection Point located at the base of the Rheostat.
Fully insert the Banana Plug into the round chamber located on the side of the Launch Box or MD Box.
Press in the Power Button on the back end of the Rheostat to engage power to the Launch Box or MD
Box. The Indicator Light inside the Launch Box should glow and screen should heat up simultaneously
in 3-5 seconds. (The Indicator Light is a tiny incandescent light seated below the trench.)
Begin to draw, a slow steady sip. If using higher heat settings (60-100% power), draw with a
slightly quicker sip to avoid combustion.
Release the Power Button to disengage delivery of power to your device.
PRO TIP: Designed to Launch you to the next level of purity, Magic-Flight offers a variety of
Water Filtration Devices: UFO, BOTTLE ROCKET, or ORBITER.
1.
2.
3.
4.
5.
6.
7.