Magnavox 15MF200V Operating manual

Quick-Use Guide
Cable Box with RF In/Out Jacks
This connection will not supply Stereo sound to the LCD TV Monitor. The sound from the Cable
Box will be monaural (single-channel, not left and right).
1
Connect the Cable TV signal to the IN jack (or RF IN or CABLE IN) on the Cable
Box.
2
Connect an RF coaxial cable (not supplied) to the OUT jack (or TO TV or RF OUT)
of the Cable Box.
3
Connect the other end of the coaxial cable to the TV jack on the LCD TV Monitor.
Screw it down finger tight.
4
Set the Channel 3/4 (or Output channel) switch of the Cable Box to 3 or 4. Set the TV to
the same channel. When watching TV programming, change channels at the Cable Box,
not the LCD TV Monitor.
TO TV
CABLE
IN
3
12
OUTPUT
CH
3 4
DC IN ANALOG
AUDIO OUT
TV
S-VIDEO
VIDEO
AUDIO
1 2
TV
There are several ways to connect your new LCD TV Monitor to your other
equipment. This Quick-Use Guide shows the easiest most common connection.
Cable TV signal from
the Cable Company
75Ω
Coaxial
Cable
75Ωjack on rear
of Television
NOTE: To see how to make other connections, please refer to the Owner’s
Manual.

Quick-Use Guide
1
6
2
4
3
5
3
5
2
4
Auto Program
1Press the MENU button on the
remote control to show the onscreen
menu.
2Press the (CH UP) or (CH DN)
buttons to highlight the TV
INSTALL menu.
3Press the (VOL-) or (VOL+) but-
tons to enter the TV INSTALL menu.
4Press the (CH UP) or (CH DN)
buttons to highlight the AUTO PRO-
GRAM control.
5Press the (VOL+) or (VOL-) but-
ton to start the Auto Program scan-
ning of channels.
6Press the MENU button repeatedly
to clear the menu from the screen.
EL6568E001
LCD TV Monitor Swivel
1Press down on the stand and gently
adjust the set to a suitable viewing
angle.
NOTE:The LCD TV Monitor can only be
tilted 20 degrees backward and 5
degrees forward.
You can adjust the LCD TV Monitor
to the left and right 60 degrees.
60
O
6
0
SWIVEL ANGLE-L
SWIVEL ANGLE-R