MAK A20 User manual

www.mak-powersis.de
A20 Vattery Cabinet USER MANUAL
A20 Battery Cabinet
Cabinet dimension o A20: 780mm×470mm×1520mm (D×W×H), including connecting wires,
air switch and wire holder. The cabinet can be mounted up to 20 pieces 65AH/12V
battery or 100AH/12V battery, each layer has pieces and five layers in total. The
external appearance is shown as Figure 1.
Figure 1
Installation Steps:
1. Place the cabinet base, then plug the V-slot of the front and rear panel into the
flume of the base’s two sides correspondingly. Shown as Figure 2.

USER MANUAL
www.mak-powersis.de
A20 Battery Cabinet
Figure 2
2. According to the accompanying wiring diagram and list, laying the batteries on the base o the
battery cabinet, connecting the wires, locking the wires on battery poles. Shown as Figure3.
Figure 3
3. Cover the 1,2,3 and racks. According to the accompanying wring diagram and list
to install the other batteries and wires. Shown as Figure .

USER MANUAL
www.mak-powersis.de
A20 Battery Cabinet
Figure 4
4. After installation is completed, checking all connections and voltage of battery are
accurate. Then install right and left side panels. Shown as Figure 5.
Figure 5
5. Cover the cabinet’s cover. The installation of battery cabinet is completed. Shown
as Figure 6.

USER MANUAL
www.mak-powersis.de
A20 Battery Cabinet
Figure 6
Wiring Method: A20 battery cabinet is placed Five groups battery. First connect the
each battery group( PCS batteries each group)in series, then connect the five battery
groups in series. Connect the anode and cathode wires to the leading-in terminal of air
switch on the rear panel, connect two wires from leading-out terminal to wire holder.
Shown as Figure 7.

USER MANUAL
www.mak-powersis.de
A20 Battery Cabinet
Figure 7: Battery wires connecting sketch-map
Notes: Don’t anti-connecting the cathode and anode of the battery, or else that will do
damage to the battery or cause other accidents.
A20 battery cabinet’s fittings. Shown as the following:
Case parts Quantity Wire Quantit
y
Remarks

USER MANUAL
www.mak-powersis.de
A20 Battery Cabinet
Base 1 Black 50mm 19 Double-ended OL15.5-8 terminal
Front panel 1 Black 1800mm 1 Double-ended OL15.5-8 terminal
Rear panel 1 Red 200mm 1 Single-ended OL15.5-8 terminal
Rack Red 300mm 1 Single-ended OL15.5-8 terminal
Side panel 8
Cover 1
Cover of Wire holder 1
C45 bracket black 1
6 A-1P/offwhite
Air switch
1
M5*25 cross pan head
screw
2
PM5*10 cross pan head
screw
1
M5T= .8mm external
hex nut
3