Mammoth MAM16X8LBF User manual

MAMMOTH MODULAR DISPLAY
MAMMOTH 16FT DISPLAY (BACKLIT)
PRODUCT CODE: MAM16X8LBF
SET UP INSTRUCTIONS
Page 1 of 2
a. Slide the Split Connectors into the grooves
of the frame and tighten
b. Attach other extrusion onto the Split Connector. c. Tighten screws with included 5mm allen
wrench.
a. Insert the Corner Connector
locks into the ends of the frame.
a. Line up the holes on feet with holes
on the bottom horizontal frame piece.
b. Insert screws and washers into
hole to secure feet to frame.
b. Insert End Lock into top and bot-
tom grooves of frame. Tighten screws
with torx key to secure connection.
2. Attach Corner Connectors:
4. Make Support Strut: 5. Attach Support Strut To Frame:
3. Install Feet:
b. Then attach side extrusion onto
the Corner Connector. Tighten screws
with included 5mm allen wrench.
a. Remove screws from
Center Connector.
a. End Lock is already attached to
opposite ends of Support Strut.
b. Insert Center Con-
nector and align holes
with holes on extrusion.
c. Repeat to connect
other extrusion to make
one long piece.
1
1
22
22
1 1
55 5
55 5
44 4
3 3 3
1. Attach Split Connectors to Top, Bottom, & Side Extrusions:

MAMMOTH MODULAR DISPLAY
MAMMOTH 16FT DISPLAY (BACKLIT)
PRODUCT CODE: MAM16X8LBF
Page 2 of 2
a. Install eighteen edge lights (36 total) on
the top and bottom of the frame.
a. Now check light strip connections. Put
male and female connectors together. Then
connect edge lights to the transformer.
b. Position light strip into inside groove of frame.
b. Hook and Loop Transformer is located on
the bottom side corner.
c. Then twist screw knobs clockwise to lock
edge lights into place.
c. Pull power cord through hole in the frame.
The hole is located under the transformer.
6. Install Edge Lights:
7. Connect Edge Lights and Transformers Together:
6
7
6
SET UP INSTRUCTIONS