Coaster 609461PPI User manual

ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE

ITEM: 609461PPI
ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
WARNING!
1. Don’t attempt to repair or modify parts that are broken or defective. Please contact the store immediately.
2. This product is for home use only and not intended for commercial establishments.
ASSEMBLY TIME PER UNIT 15 MINUTES
PARTS IDENTIFICATION
A BASE 1 PC
B LEFT BACK 1 PC
C MIDDLE BACK 1 PC
D
RIGHT BACK
1 PC
E POWER CABLE FOR READING LIGHT 1 PC
F POWER CABLE 1 PC

ITEM: 609461PPI
ASSEMBLY INSTRUCTIONS
STEP1
STEP2
STEP3

ITEM: 609461PPI
ASSEMBLY INSTRUCTIONS
SHOW1
SHOW2

ITEM: 609461PPI
CONTROLLER INSTRUCTIONS

ITEM: 609461PPI
VOICE CONTROL
1. The microphone of voice control is in front of the controller. It’s the best
communication effect if you talk to the microphone direction correctly.
2. Before using voice control, you need to wake up the system by voice command
Hello Coco. When the system recognizes the command, it will be waked up and say
“Hello” as a response.
3. You can use "name + command" to control the chair after the system is waked up.
For example, "Coco Recline", the chair will recline after the command is recognized.
The specific commands are attached <Commands List>
4. If the broadcast sound is too low, you can also say "Coco, I can't hear you!” to
adjust the volume to the default. Or you can say “Coco Maximum Volume” to adjust
to maximum volume.
5. Memory function: It can record three positions, Sleep Position, TV Position and
Reading Position. For example, when the sofa is adjusted to the appropriate sleep
position, say "Coco Set Sleep Position", and the sofa will record the position. Next
time, you can say "Coco Sleep Position", the sofa will automatically adjust to the
previous sleep position.
6. It will enter into sleep mode if no command in 20 seconds. You must say "Hello
Coco" again to wake up the system.
7. Double tap the Home button, it will broadcast the current name and prompt the
user how to rename it. Then you could double tap the Home button to rename it.
During 20 seconds you could rename it again for double tap the Home button. Six
names are added: Bella, Coco, Miya, Opal, Rose, Sally. It will exit the rename state
if there are other operations in 20 seconds.
Notice
1. If there are several commands for one action, any of the command is valid.
Commands list as attached.
2. Fluent expression of voice commands will make the recognition better.
3. The commands “Stop” and "Coco Stop" has a high priority. Say "Coco Stop" or
Stop, the actuator will stop immediately.
4. The new command will be executed immediately if a new command was given
when actuators are in motion. For example, if a new command, "Coco Home
Position", is recognized during the command of recline, the sofa will reset immediately.
5. The actuators will stop immediately when press any button of the controller.

ITEM: 609461PPI
COMMANDS LIST

ITEM: 609461PPI
Note : Dimension tolerance ±5%