MANCHESTER WOOD MISSION 7401 User manual

MISSION PRINTER CART
Thank you for purchasing our Mission Printer Cart. Assembly of this
product requires the use of a Phillips screwdriver and hammer. We have
found it helpful to have second person assist with assembly.
7401/7441 121108

STEP 1
Read through these instructions thoroughly
before beginning assembly. We have
found this to be of great value when first
assembling this product.
STEP 2
Remove all parts and hardware from
packing material. Wooden pieces should
be placed on a non-abrasive surface (like
the carton or carpet) to prevent damage to
the finish.
STEP 3
Identify all parts using diagram at right
PARTS
(1) Top Assembly (A)
(2) Side Assembly (B)
(2) Shelf Assembly (C)
STEP 4
Identify and count hardware using
diagram at right.
STEP 5
Align Side Assembly (B) with
Bottom Shelf (C) so that the
predrilled holes on the corners of
the legs are facing in towards the
center of Shelves (B) so that the
larger countersunk holes are
facing away. The diagram to the
right shows the proper placement.
A second persons assistance
would be recommended to hold
shelving (C) being worked on.

STEP 6
Align 2nd Side Assembly
with Bottom Shelf (C) as
shown in STEP 5.
STEP 7
Align 2nd Shelf Assembly (C) with
Side Assemblies (B) as shown.
A second persons assistance would be
recommended to hold shelving (C)
while both sides are screwed into
place.
STEP 8
Place Top Assembly (A) as shown to
the right so that holes in Sides (B) line
up with holes in the corner brackets of
Top Assembly (A). Fully tighten
screws so the Top Surface and Side
Assemblies are fastened.

STEP 9
Tap Wooden Plugs into holes with
hammer to conceal screws.
STEP 10
Push Casters into the bottom of Side
Assemblies (B) until you feel them
snap into place. Inserts are already
placed in base.
CARE
Dust as needed with a soft cloth. Clean
with damp cloth and mild solution of dish
soap. Polish with soft cloth and polish that
contains no pigments or silicone.
www.manchesterwood.com
Product Support 1-800-660-6930