
Marbletrend Easy-Fit Polymarble Shower Base
Page 1 of 2
Installation Instructions
Easy-Fit
SHOWER BASE INSTALLATION INSTRUCTIONS
Install base on mortar bed
or cement-based tile
adhesive
Test water drainage to
waste
120mm max.
300 x 300mm max.
Smartpan/Smartwaste fitting -
lid/cover must remain on
Timber floor
Concrete slab
Villaboard or
water resistant
wall lining
Sealant
Tiles or wall
sheeting
Bottom
Plate
Mortar bed or Adhesive
Check-in base
as required
A
B
C
D
E
A. PRE-INSTALLATION NOTE
B. TIMBER FLOOR
Note:
Do not use ‘Liquid Nails’ or similar rigid construcon-type adhesive to
install base.
At this point it is imperave to check that water drains to the waste
outlet prior to lining the shower walls. Failure to do so is
a breach of warranty.
C. CONCRETE SLAB
Do not use ‘Liquid Nails’ or similar rigid construcon-type adhesive to
install base.
At this point it is imperave to check that water drains to the waste
outlet prior to lining the shower walls. Failure to do so is
a breach of warranty.
Note:
D. SMARTPAN/SMARTWASTE
Plumbers, please ensure a copy of the Installation
Instructions are left with the end user for future reference