Mark Bric ISOFrame fabric IS-9591 User manual

Start prole 1000 mm - Item IS-9590
End prole 1000 mm - Item IS-9591
End prole
1000 mm - Item IS-9591
Start prole
1000 mm - Item IS-9590
End prole
1000 mm - Item IS-9591
Start prole 1000 mm - Item IS-9590
End prole 1000 mm - Item IS-9591
Start prole
1000 mm - Item IS-9590
Label mark: Bottom prole
Label mark: Top prole
Label mark: Side 1 (Sade 1A, 1B)
Label mark: Side 2 (Side 2A, 2B)
Mount the frame
You must lock all joints with screw brackets
in each side.
Lightbox frame
This frame can be used single- or double sided. You always need fabric graphic
on both side (printed or unprinted), unless you will use it as a wall mounted
frame on a white wall, in which case it’s not necessary to use fabric on the
reverse side.
Corner connection.
Straight connection.
Mount the feet
Item no: IS-9338 (Minimum 2 pcs.)
The frame must be drilled for the feet on the bottom
prole.
1
Mount a foot in each side of the bottom prole.
VERY IMPORTANT!
Before you connect the LED-
bar, read how to connect!
See reverse side.
Frame size: 200 x 200 cm

Mount the LED-bar
1
Attach the bar with twist nuts into the centre slot in the
prole. 2
Lock the two screws with the Allen-key. 3 Insert the adaptor cable in the hole in the prole. Each
hole ts 2 cables.
6Hide the cable in the side slot and secure it with a tape .
Mark Bric Display Corp.
North America Tel. [phone] Fax [phone] E-mail: [email protected]
Mark Bric Display AB
Worldwide Headquarters Tel. [phone] Fax [phone] E-mail: [email protected]
4
Connect the contacts from the LED-bar to the adaptor
cable. 5Add more LED-bars and connect with that before, approx 10 mm from the rst one.
Transformer 1
Transformer 2
Connection 200 x 200 cm
Consists of :
2 pcs. Transformer
2 pcs. Adaptor cable
20 pcs. LED bars
Don’t connect
the red and blue
Connect the LED-bar and transformer
VERY IMPORTANT!
- Do not connect more than 10 pcs. of LED bars
to each power supply (transformer), item IS-9381.
- Do not put transformers inside the lightbox.
- Do not cover the transformers.
- Do not put transformers together.
Risk of overheating!
Mark Bric Display can not be held responsible for any misuse,
failure to follow the Mark Bric instructions and/or errors during the
electrical installation of the light boxes.