Mark Bric ISOframe ripple IS-9835 User manual

APush the top and bottom knob into the center and remove
the screen holder. BMount the screen holder at your screen or iPad holder.
Follow reverse side
Ripple
Media screen holder
For media sreen with VESA 75/100 or our
iPad holder (80029)
Item no. IS-9835
Please observe: We do not recommend
using a media screen holder on a single
free-standing banner stand section.
1
Remove the top post and replace it with the media screen
holder without the black holder (see photo instruction A). 2
Build up the complete wall and attach the graphic panels. 3 Mount the screen (see photo instruction B) and then push
the screen holder into the post holder while at the same
time pressing the two buttons on the post holder together.

Graphic measurement
420 mm / 16.5”
Item 9514 - 2015.07.01
Mark Bric Display Corp.
North America Tel. [phone] Fax [phone] E-mail: [email protected]
Mark Bric Display AB
Worldwide Headquarters Tel. [phone] Fax [phone] E-mail: [email protected]
Make a 70 x 140 mm / 2.75 x 5.5” hole in
the center of and 420 mm / 16.6”
from the top.
70 x 140 mm
2.75 x 5.5”