Use of the Masterlink MICC with the Mass Combi
Mastervolt
International
B.V,
P.O.Box 22947, NL-1100 DK Amsterdam, The Netherlands. Tel.: +31-20-3422100 Email: [email protected] Web: www.mastervolt.com v1.2 071206EN
DAILY USE OF THE MASTERLINK MICC:
Adjustment of the Power sharing / Power
support level
When the available current from the AC source is
limited (for instance to avoid the shore fuse from
tripping), the maximum AC input current of the Mass
Combi can be limited. Follow the steps below:
VOLT & CHG.AMP
25.54V 0.3A
VOLT & CHG.AMP
25.54V 0.3A
Press Charger once
POWER SHARING.
25.0A Ç
Hold Select pressed for 5 sec. to change the arrow’s
direction. If pointing upwards (Ç), the Power sharing /
Power support level can be increased; if pointing
downwards (È), it can be lowered.
Press Set-up several times to adjust the Power
sharing / Power support level
After adjustment, press Select once
EXIT LEVEL
->PRESS SET-UP
Press Set-up once.
Now the Select-LED stops blinking
VOLT & CHG.AMP
25.54V 0.3A
Ready!
Hold Select pressed until the
Select LED starts blinkin
Power Support Function
The Power Support Function can be enabled by means
of DIP-switch B-SW4. If enabled and the total demand
for AC power is more than the Power Sharing level,
load connected to the Short Break output will be
powered by the inverter while load connected to the
Power output will be powered by the external AC-
source. See sections 3.3.5 and 6.2.2 of the user’s
manual of the Mass Combi for more information.
DIP switch B SW4
Power support function disabled OFF
Power support function enabled ON
INITIAL DIP-SWITCH SETTINGS AT THE MASS COMBI (CONTINUED)
Generator / mains support function
With the Generator / mains support function enabled,
AC power from the inverter is added to both AC outputs
if the total demand for AC power is higher than the
Power Sharing level. See section 3.3.4 and 6.2.3 of the
user’s manual of the Mass Combi for more information.
DIP switch B SW5
Generator / mains support function disabled OFF
Generator / mains support function enabled ON
6 INITIAL SETTINGS AT THE MASTERLINK
MICC
Start from the initial menu to configure the
Masterlink MICC for use with the Mass Combi.
VOLT & CHG.AMP
25.54V 0.3A
Hold Select pressed until the
Select LED starts blinking
VOLT & CHG.AMP
25.54V 0.3A
Press Set-up once
SLEEP MODE
ON
HFC mode
OFF
Press Select 3 times
Press Set-up once to enable the HFC mode
HFC mode
ON
Press Select once
EXIT LEVEL
->PRESS SET-UP
Press Set-up once.
Now the Select-LED stops blinking
VOLT & CHG.AMP
25.54V 0.3A
Ready!
7
