
Components included
Head unit Surface
mount bezel
Bayonet collar
MasterBus cable*
(6m / 20ft)
MasterBus Terminator*
4 × Phillips
countersunk
self-tapping
screws (2.9×16)
If you are not knowledgeable about electrical
systems, have an electrical professional install this
unit.
WARNING
CAUTION
The SmartRemote is not waterproof. Do not install
where the display is exposed to water.
Contact your local waste disposal depart-
ment to properly dispose of the unit.
Correct Disposal
On first use
Operation Notes
Specifications
Mastervolt CZone Drop Cable*
(1m / 3.3ft)
SmartRemote
QuickStart Installation Guide
*Need to be ordered separately with OEM packaging
P1 P2 P3
Model:
Product code retail:
Product code OEM:
Dimensions:
Screen:
Weight:
Operating temperature:
Relative humidity:
Storage temperature:
Power supply:
Power consumption:
Protection degree:
Approvals:
Interfaces:
SmartRemote
77010600
77010500
72×72×30 mm/2.8×2.8×1.2"
320x240 pixels,
16 bits color, 2.8"
75 g / 0.2 lb
-20 to 55°C/-4 to 131°F
max. 95% non-condensing
-30 to 70°C/-22 to 158°F
bus powered, 11-14V *
<180mW (idle mode)
IP20
CE
MasterBus,
CZone (upcoming)
*The paired device must have MasterBus
powering set to on.
Meaning of the icons
Device state (inverting/charging/standby)
Battery voltage or charging current
Output power (AC OUT)
Shore power (AC IN)
Energy left in battery (State of Charge)
Time remaining during discharge
When the SmartRemote is added to a MasterBus
network, it will scan for available supported
devices to pair with. If there is only one device, it
will automatically pair with this device. If there are
multiple devices, it will ask to select a device.
The three push buttons P1, P2 and P3 provide a
scroll and select function. Their behavior depends
on the paired device. When idle, the button menu
slides down. To get it back, press any button.
To wake up from standby mode, simultaneously
press P1 and P3 to enter the main menu. Standby
time can be changed.
How to switch an inverter e.g. on or off?
When the SmartRemote is active, press any key to
reveal the sub menu. Press P1 to switch on or off.
How to adjust the power sharing level?
When the SmartRemote is active, press any key to
reveal the sub menu. Press P2 or P3 to select the
required AC IN limit.
How to select another device?
First, unpair the currently paired device:
simultaneously press P1 and P3 to enter the main
menu. Scroll down to Unpair device and press the
checkmark button. Confirm the action by pressing
the checkmark button again. The SmartRemote
will scan for available devices. If there is only one
device, it will automatically pair with this device. If
there are multiple devices, it will ask to select a
device.
When changing the
language, be aware
that language of the
SmartRemote and
language of the
paired device are two
separate settings!