MATTRESS FIRM 600 User manual

owner manual
H-122 T/F/Q
600
Adjustable Base

CONTENTS
READ ALL INSTRUCTIONS BEFORE USING
If adjustable base does not operate or if parts are missing, call:
844-MATT-FRM
Advisory...................................................................................................................... 4
Assembly .................................................................................................................... 6
Remote Control Function............................................................................................ 10
Power Down Operation ............................................................................................... 11
Troubleshooting ......................................................................................................... 12
Warranty ................................................................................................................... 13
REGISTER YOUR BASE
To register your base, go to:
https://lpadjustablebeds.com/register

4
ADVISORY
ELECTRICAL RATING
Input: 100-240VAC, 50/60Hz, 1.6A.
ELECTRICAL GROUNDING
This product is equipped with a polarized or grounded
electrical power cord. The power cord will only fit into a
grounded, electrical surge protection device (not included)
or a grounded electrical outlet.
WARRANTY WARNING
Do not open any control boxes, motors or remote control
devices (with the exception of the remote control and
power down battery compartments). The product warranty
will be void if these components are tampered with. Do
not attempt to alter component wiring or adjust or modify
the structure of the product in any way or the warranty
will be void. Any repair or replacement of base parts must
be performed by authorized personnel.
LUBRICATION
This product is designed to be maintenance free. The
lift motors are permanently lubricated and sealed—no
additional lubrication is required. Do not apply lubricant
to lift motor lead screws or any nylon nuts or the base may
inadvertently creep downward from the elevated position.
LOCATION ENVIRONMENT
The level of sound experienced during operation is directly
related to the location environment. For example, when
a base is located on a hardwood floor with the massage
feature in operation, a vibrating tone will be audible.
It is possible to experience vibration or noise from the
headboard brackets, headboards or footboards if mounting
bolts are not firmly tightened.
FOR OPTIMUM ADJUSTABLE BASE
OPERATION, USE A GROUNDED, ELECTRICAL
SURGE PROTECTION DEVICE (NOT
INCLUDED). FAILURE TO USE A SURGE
PROTECTION DEVICE COULD COMPROMISE
SAFETY OR CAUSE PRODUCT MALFUNCTION.
WARNING
!
READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT
IMPORTANT INFORMATION
SERVICE REQUIREMENTS
Service technicians are not responsible for moving
furniture, removing headboards and footboards or any
items required to perform maintenance on the base. In
the event the technician is unable to perform service due
to lack of accessibility, the service call will be billed to
the purchaser and the service will have to be rescheduled.
PRODUCT RATINGS
The base lift motors are not designed for continuous use.
Reliable operation and full life expectancy will be realized
as long as the lift motors do not operate any more than
two (2) minutes over a twenty (20) minute period, or
approximately 10% duty cycle. Note: Massage equipped
bases are not designed for continuous, extended massage
operation. Massage systems are rated for a maximum of
2 hours of use within any 6 hour period. Any attempt to
circumvent or exceed product ratings will shorten the life
expectancy of the product and may void the warranty.
The recommended weight restrictions for these adjustable
bases is 850 lb (385 kg) all sizes. The base will
structurally support the recommended weight distributed
evenly across the head and foot sections. This product is
not designed to support or lift this amount in the head or
foot sections alone. Note: Exceeding the recommended
weight restrictions could damage the base and void the
warranty. Depending on the size and/or model of mattress,
the available weight capacity may be less.
For best performance, consumers should enter and exit
the adjustable base with the base in the flat (horizontal)
position. DO NOT SIT ON THE HEAD OR FOOT
SECTIONS WHILE IN THE RAISED POSITION.
Motors and electronics have been ETL tested to UL
(Underwriters Laboratories) standard UL962.
CFR 1633 approved for use with most mattresses.
Assembled in USA.

5
ADVISORY
READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT
IMPORTANT INFORMATION
SMALL CHILDREN / PETS WARNING
After the base is unboxed, immediately dispose of packaging
material as it can smother small children and pets. To avoid
injury, children or pets should not be allowed to play under
or on the base. Children should not operate this base without
adult supervision.
HOSPITAL USE DISCLAIMER
This base is designed for in-home use only. It is not
approved for hospital use and does not comply with
hospital standards. Do not use this base with tent type
oxygen therapy equipment, or use near explosive gases.
Manufacturer makes no representation or warranty that
the adjustable base constitutes a medical device or is
suitable for medical or therapeutic use.
LIFTING/LOWERING MECHANISMS
The lift/lower feature will emit a minimal humming sound
during operation. This is normal.
During operation, the lift arm wheels make contact with the
platform support of the base. This applies slight tension
on the moving components and resonance is reduced to a
minimum level. If excessive noise or vibration is experienced,
reverse the movement action (up or down) of the base with
the remote control. This should realign the base’s activating
mechanisms to the proper operational position.
FCC COMPLIANCE
The equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a residential environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning off the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
Radio Frequency = 2.4 GHz.
FABRIC CLEANING INFORMATION
Spot clean only with water based shampoo or foam
upholstery cleaner. Pretest a small, inconspicuous area
before proceeding. Do not over wet. Do not use solvents
to spot clean. Pile fabrics may require brushing with a
non-metallic, stiff bristle brush to restore appearance. Hot
water extraction or steam cleaning is not a recommended
cleaning method.
To prevent overall soiling, frequent vacuuming or light
brushing with a non-metallic stiff bristle brush to remove
dust and grime is recommended. When cleaning a spill, blot
immediately to remove spilled material. Clean spots or stains
from the outside to the middle of the affected area to prevent
circling. Use a professional furniture cleaning service when an
overall soiled condition is apparent.