Maxilux H3-RCV-4CV User manual
H3-RCV-4CV Instructions
Quick Start
This is a 4 channel receiver which will work with any DC lamp in the 12-24v range
- RGB or RGBW - control a single length
- CCT LED Strip - control 2 lengths
- Single Colour - control up to 4 lengths
1. Connect your power supply to the input side - DO NOT CONNECT MAINS VOLTAGE
- THIS WILL DESTROY THE UNIT.
2. Match the receiver to the type of lighting you are
using. By default it is set for RGBW.
To select the type, press M & < keys together for 2
secs - the display will then change indicating you
are in Setting mode. Pressing the > key will cycle
through the available options:
RGBW - Ch4 (notice upper case C and lower case
h)
Single Colour - all connected lengths controlled at
the same time - select Ch1
Single Colour - each connected length can be
controlled individually - Select CH4 (notice both are
upper case)
Colour Temperature adjustable - select Ch2
RGB : Select Ch3
3. Connect your LED Strip or lamps to the output
side.
Wiring Diagram
Multiple Pairings
Your Halo30 receiver can be paired to multiple controllers - so for example, if you wish
to have both a hand held remote and a wall mounted switch, both can be paired to the
receiver and used as required.
Deleting Pairings
Should you wish to delete all pairings, press the M & > keys together for 5 seconds
until the display changes to ALE.
4. The receiver goes into pairing mode
by pressing M & > for 2 seconds - the
display will then change to read ALS.
Each controller in the Halo30 system
may have a slightly different system
of pairing to the receiver - refer to the
controller instructions for full pairing
information.
When pairing is successful the display
on the receiver will change to ALO.
How to put your receiver into pairing mode
• Long press and for 2s, restore factory default parameter, display”RES”.
• Factory default parameter: without matched remote, RGBW type, low PWM
frequency output, logarithmic brightness curve, RGB mode number is 1, disable
automatic blank screen.
• Long press M for 2s or timeout 10s,Please be aware that this will not retain
previously saved LED settings once system parameter settings have been exited.
Safety Information
Malfunctions & Troubleshooting
• The product shall be installed and serviced by a qualied person.
• The product is non-waterproof. Please avoid the sun and rain.
• Good heat dissipation will prolong the working life of the controller. Please ensure
good ventilation.
• Please check if the output voltage of any power supplies used comply with the
working voltage of the product.
• Ensure all wire connections and polarities are correct and secure before applying
power to avoid any damages to the LED lights.
• If a fault occurs please return the product to your supplier. Do not attempt to x
this product by yourself.
Restore Factory Default Settings
Malfunctions Causes Troubleshooting
No Light 1. No Power
2. Wrong Connection or Insecure
1. Check Power
2. Check Connection
Wrong Colour 1. Wrong Connection of R/G/B/W Wires 1. Reconnect R/G/B/W Wires
Uneven Intensity /
Voltage Drop
1. Output Cable Is Too Long
2. Wire Diameter Is Too Small
3. Overload Beyond Power Supply Capability
4. Overload Beyond Controller Capability
1. Reduce Cable/Loop supply
2. Change Wider Wire
3. Replace Higher Power Supply
4. Add Power Repeater
No Response From
Remote
1. The Battery Has No Power
2. Beyond Controllable Distance
3. The Controller Did Not Match The Remote
1. Replace Battery
2. Reduce Remote Distance
3. Re-Match The Remote
