Maxx Cold X Series User manual

REACH-IN REFRIGERATORS AND FREEZERS

onthelastpage.
8-15
Service and Installation Manual

6
9
10
11
12
16
Service and Installation Manual
MXCR-23FD
MXCR-49FD
MXCR-72FD
MXCF-23FD
MXCF-49FD
MXCF-72FD
14.1
25
28.9

All models are supplied with casters for your convenience,
ease of cleaning underneath and for mobility. It is very
important, however, that the cabinet be installed in a stable
condition with the front wheels locked while in use.
Service and Installation Manual

Condenser probe failaneP3
CSd Condenser alarm
34 38
3.1 HOW TO SEE THE ALARM AND RESET THE RECORDED ALARM
SOLID-S TA TE THERMOS TA T DESCRIPTIONS :
1. Push the UP or Down key, the alarm signals are displayed.
2. When the signal is displayed, hold the SET key untill the "rst" message is displayed, and push the
SET again, the "rst" message starts blinking and the normal temperature will be displayed.
fans will run continuously even when one or more doors are open.
The door switch will activate the lights when opened.
Anti-condensation heaters on door frames work in
conjunction with the compressor.
Anti-condensation heaters on door frames work in
conjunction with the compressor.
is
is .
.
Service and Installation Manual

Service and Installation Manual

Service and Installation Manual
Open the top shroud
Loosen the screws on the bottom of top shroud, then swing
top shroud up 180° until it rest on top of the cabinet.
Door Replacement and Adjustment
1. Open the top shroud and swing it up until it rest on top of
the unit.
2. Open the door to about 100-110° until the door remain
open.
3. Loosen and remove the top screw of self-closing
cartridge and the three hinge screws, then slide the door up
and out.
4. Prepare new door. Use a wrench to rotate the square
head of the cartridge shaft approximately 120° in the
closing direction of the door. The hinge is now preloaded
and ready to be secured to the top hinge
5. Hold the door at about 100° from the close position,
insert the top hinge over the square shaft of the cartridge so
that the hinge is facing the cabinet. Insert the mounting
screw and fasten securely.
6. Still holding the the entire door/hinge assembly at about
100°, slide it over the bottom hinge pin, make sure all the
alignment then fasten the upper hinge securely
7. Allow the door to freely swing, make sure it swing close
by itself with no restriction
and active the evap fan when door close
9. If not, adjust the door height by adding the plastic
spacer/washer provided to the bottom hinge pin
Remove the bottom shroud (apply to bottom-mounted

MXCR-23FD
MXCR-49FD,MXCR-72 FD
Service and Installation Manual

Service and Installation Manual
MXCF-23 FD
MXCF-49FD, MXCF-72 FD

ＭＸＣＲ－２３ ＦＤ
Service and Installation Manual

Service and Installation Manual
ＭＸＣＲ－４９ ＦＤ

Service and Installation Manual
ＭＸＣＲ－７２ ＦＤ

ＭＸＣＦ－２３ ＦＤ
Service and Installation Manual

Service and Installation Manual
ＭＸＣＦ－４９ ＦＤ

Service and Installation Manual
XCF-72 FD

MAXXCOLDFOODSERVICE.COM