Mayline CSII FREESTANDING PENINSULA C625 User manual

ASSEMBLY INSTRUCTIONS
CS II FREESTANDING PENINSULA
COMPONENTS:
REF. # QTY. DESCRIPTION PART No.
1 1 WORK SURFACE CALL~~**
2 1 LEG CALL~~**
3 1 POST LEG B5185
HARDWARE BAG (PART No. A7646) *for individual part, order that part number
REF. # QTY DESCRIPTION PART No.
E1 12 #10 X 3/4 SCREW X11*
E2 2 GLIDE Q444*
NOTE: Please count and inspect all pieces before disposing of any carton or packing materials.
CATALOG No:
C625
C626
C627
C635
C636
C637
C645
C646
C647
When ordering components, specific color and/or size information may be required.
Contact a Mayline Customer Service Representative. 1-800-822-8037
** Denotes Color Code
~~Denotes Size
(1)

Freestanding Peninsula Assembly:
NOTE: Size may vary but assembly procedure remains the same.
1. Place the Work Surface (1) face down onto a clean, protected surface.
2. Position Leg (2) approximately 3/16 from the edges and align the holes in the Leg with the pre-drilled holes in
the Work Surface. Attach Leg to Work Surface with seven Screws (E1).
3. Tighten all screws.
4. Install two Glides (E2) into Leg.
5. Align the holes in the Post Leg (3) mounting plate with the pre-drilled holes in the Work Surface. Secure the
assembled Post Leg using four screws (E1).
6. Place the assembled peninsula in the upright position. MAYLINE recommends that a minimumn of two
people perform this task.
7. Place the peninsula at the location where it will be used. MAYLINE recommends that a minimumn of two
people perform this task.
8. Level the assembly by adjusting the glides.
(2)

Freestanding Peninsula Assembly:
NOTE: Size may vary but assembly procedure remains the same.
(3)