Maytag DC68-01052A User manual

5.
2.
6.
1.
S T AC K ING K IT INS T AL L A T ION
1)P osition the unit on a level s urface,
capable of s upporting the entire
weight of the dryer.
R emember that the unit will be
heavier when it is fully loaded.
C lea n the surface where the stacking
kit is going to be installed.
P lace the mounting bracket on the
Washer as indicated.
2) R emove the 2 plastic covers (shown in figure 6) attached
to the middle of the stacking kit, and save thes e for
later use. R emove the double back tape and firmly attach
the stacking kit the top of the washer to assure the
proper s eal.
 Make sure the word F R ONT printed on the stacking kit
is facing forward as shown above.
3) P ut back edge of stacking kit to back mold line of washer’s
top cover and tighten the screw.
5) Y our Dryer is equipped with 4 leveling legs.
 Make sure they are lowered 10 mm, so there is a
gap between the legs and the dryer bas e.
6) G ently pus h the drye r into pos ition as
indicated in figure 5 & 6, sliding the unit into
the slots provided.
It is important that the dryer is level.
 Make sure all four leveling legs are pushed
all the way back into the s lots to ensure
 proper mounting.
3.
6.
4) Install all 7 s crews provided with a power drill
and tighten the stacking kit to the unit base securely.
4.
8.
DC68-01052A
7) Insert the plastic covers
(removed in section 2)
covering the two front
 slots of the leveling legs.
 Depending upon the
location of the unit, it may
be neces s ary to change
 the side on which the dryer
door opens.
7.
( back )