MB QUART Polaris General MBQG-RPOD-1 User manual

Page 1 of 4
Installation Instructions
Model: Polaris General
Description: Rear Pods Install
Part Number: MBQG-RPOD-1
Assembly Time: 45 Min
No. Component Name Qty
1 6.5” Rear Pod Speakers (MBQG-RPOD-1) 2
1 13mm Wrench
2 4mm & 5mm Allen Wrench
Parts List
Tools Required
Before you begin, read through these instructions and check that
all parts are present. Always disconnect negative battery terminal
prior to installation. Please note that MB Quart cannot assume any
responsibility for damage resulting from incorrect installation.

Page 2 of 4
Rear Speaker Install
● Attach the left and right harness
to bullet connectors in the center
console and then route these
to the left and right side of the
vehicle staying clear of moving
and hot parts
NOTE
If you have a MB Quart Stage
3 kit then proceed. If you are
adding the rear speakers to any
other audio system run wires to
your amplifier location
● Install speaker to bracket with
four M6 Button head bolts using a
4mm Allen wrench, then position
bracket on the ROPS with four
M8 bolts, eight M8 washer, and
four M8 locknuts securing with
a 5mm Allen wrench and 13mm
socket
● Inside bracket should have grove
facing toward center of vehicle

Page 3 of 4
Rear Speaker Install
● Connect wiring

Page 4 of 4
MBQG-RPOD-1 REV 01
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a mobile installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
WARNING: Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complied with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
MBQuart products are designed and engineered in the USA by
www.maxxsonics.com
WARRANTY
Maxxsonics USA Inc. warrants this product, to the original consumer purchaser, to be free from defects in material and workmanship for a period of one (1) year from
the date of purchase. Maxxsonics USA Inc. will, at it’s discretion, repair or replace defective products during the warranty period. Components that prove to be defective
in materials and workmanship under proper installation and use must be returned to the original authorized Maxxsonics USA Inc. retailer from where it was purchased.
A photocopy of the original receipt must accompany the product being returned. The costs associated with removal, re-installation and freight are not the responsibility
of Maxxsonics USA Inc. This warranty is limited to defective parts and specically excludes any incidental or consequential damages connected therewith. To view the
full warranty, please visit the website.
The Bluetooth®word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use such marks by MB Quart is under license.
All product names, logos, and brands are property of their respective owners. All company, product and service names used in this literature are for identication purposes
only. Use of these names, logos, and brands does not imply endorsement.
©2021 Maxxsonics USA, Inc.