MB QUART N1-RFBT Instruction Manual

Quick Start
Installation Guide
ffi!AJ rn5D
QUART
N1-RFBT
®
Wireless Bluetooth® Controller

Congratulations on your choice of a MBQuart Bluetooth
controller. This "Quick Start" Installation guide is meant to
help you complete a basic installation. For more detailed
information, visit our website at MBQuart.com
I
• CAUTION I
•
Always consider consulting a professional audio installer
before installing any audio components. Be careful and take
your time. Do not let wires make contact with metal edges or
hot engine components.
Flush Mounting
This method will allow the controller to sit flush to the mounting
surface. This requires a perfectly flat surface and ideally should have
access to the rear
of the mounting panel.
Before drilling the mounting hole, make sure there are no
obstructions behind the mounting area.
l ~~ ... ~b
35mm (1-3/8") 8
minimum clearance
55mm
2.18" (2-3/16")

Surface
Mounting
The controller can be mounted on any flat surface using the surface
mount cradle. This will allow the controller to be removed for use
in
hand as well as kept
in
the cradle when not
in
use.
Before drilling any holes make sure there are no obstructions behind
the mounting surface. Also make sure there is enough space around
the cradle to remove and replace the controller easily.
Battery
Replacement
The controller battery can be changed by sliding the access door
downward.
CR2032
0

Wiring
The wiring and connections should be secure and away from any
moving parts or extremely hot surfaces.
The RCA pre amp output can
be
connected directly to
an
amplifier.
The RCA aux input can be used to connect a secondary source.
The IGN wire should be connected to a switched +12V source.
The remote output wire provides a +12V output to turn on an
amplifier.
PREAMP
OUT
AUXIN
REMOTE
OUT
c:=::1
________
_,
GROUND
(black)
c::::::::~
---------~~~""'
+12V
(red)
IGN
(blue)
0
Status Indicator
USB
Charger

Controls
0 Volume UP -Each press will increase the volume.
f) Volume DOWN -Each press will decrease the volume.
E)Track UP -Press to advance to the next track.
Q Track DOWN -Press to restart the current track or to back up to previous tracks.
0 PLAY I PAUSE -Press once to pause. Press again to play.
0 Mode -One press will toggle between Bluetooth function and the auxiliary input.
0 Volume UP
Volume DOWN 0
QTrack DOWN Track
UP E)
0 PLAY I PAUSE Mode 0
Bluetooth Device Pairing
The pairing process can vary based on your particular device.
Refer to the operating instructions
of your device. Below is the
general process to connect the controller.
The status indicator will flash slowly when "searching" for the last paired device. If no
device is located, it will flash quickly indicating it is ready to pair to a new device.
On your Bluetooth enabled device, search for "MB QUART" under Bluetooth settings.
Select MB QUART, wait for the device to indicate "connected".
The status indicator will change to solid blue.
Music will now play through the system.
Auxiliary Input
A secondary device can connected through the AUX INPUT.
Pressing the MODE button will switch to this input. The status
indicator will change to solid red.
To return to Bluetooth operation
press the MODE button again.

M BOuart.corn
#MUSIC DEFINED
WARRANTY
Maxxsonics USA Inc. warrants this product, to the original consumer purchaser, to
be free from
defects
in material and workmanship for a period of one (1) year from the date of purchase.
Maxxsonics USA Inc. will, at it's discretion, repair or replace defective products during the warranty
period. Componentsthatprove to be defective
in materialsand workmanship underproperinstallation
and use must be returned to the original authorized Maxxsonics USA Inc. retailer from where it was
purchased. A photocopy of the original receipt must accompany the product being returned. The
costs associated with removal, re-installation and freight are not the responsibility
of Maxxsonics
USA Inc. This warranty
is limited to defective parts and specifically excludes any incidental or
consequential damages connected therewith.
To view the full warranty, please visit the website.
MBQuart
products are designed and engineered in the USA by
tvtAXX.S"DNIC:S®
84 7-540-7700
www.maxxsonics.com
MBQ N1-RFBT QSG 01- revS