Performance
Specif ications
AMPLIFIER SECTION FM SECTION
STEREO POWER OUTPUT USABLE SENSITIVITY
100 watts into I ot- 4 ohm loads is the l3dBF which is 1.22uV across 75 ohms
minimum sine wave continuous average
power output per channel, from 20 to 50 dB SUIETING SENSITIVITY
2OrO0OHz, with both channels operating. Mono 17dB which is 2.0uV across 75
onms
POWER BANDWIDTH Stereo 37dBF which is 20uV across 75
20 to 20,000H2 ohms
TOTAL HARMONIC DISTORTION SIGNAL TO NOISE RATIO
O.O2% maximum at any power level from Mono 75dB
25O mi.l.liwatts to rated power per channel , Stereo 70dB
20 lo 20,0OOHz, both channels openating. FRESUENCY RESPONSE
iNTERMODULATION DISTORTION Mono *0, -1.OdB from 20 Io 15kHz
O.O2% maximum at any power level from Stereo +0, -1 .gdB f rom 20 to 'l SkHz
25O milliwatts to rated power per channel,
for any combination of frequencies from 20 HARMoNIC DISTORTION
Io 2O,000H2, with both channels operating. Mono O.Og% at 100H2
O.O8% at lk
FREOUENCY RESPONSE O,12% at 1Ok
+0, -0.5d8 from 20 to 20,0001-lz at rated Stereo O.OB% at 100H2
power. 0.08% at 1k
O.120Á at 10k
INPUT SENSITIViTY
phono z.smv produces rated output INTERMODULATION DISTORTION
Tape, Aux 2S0mV produces rated output Mono o'o8oÁ
Power- Amp 1.5V produces rated output Ster-eo o'120/o
SIGNAL TO NOISE RATIO, A-WEIGHTED CAPTURE RATIO
Power Amp 1OOrJB below rated output 1'5dB
Tape, Aux 90dB below rated output
phono 8OdËt with 10mV input ALTERNATE CHANNEL SELECTIVITY
55dB
MAXIMUM INPUT SIGNAL
Phono 90mV SPURIOUS RESPONSE
High level 9V loodB
INPUT IMPEDANCE IMAGE RESPONSE
Phono 47k ohms, 4TpF SodB
Tape, Aux 30k ohms
power Amp 22k or,m STEREO SEPARATION
45dB at 100H2
DAMpING FACTOR 50dB at 'l k
creater than 40 35dB at 1ok
TAPE OUTPUT SCA REJECTION
Phono 250mV with rated input 65dB
Tape 250mV with rated input
Tuner O.BV at 1OúÁ modulation (FM)
PROGRAM EOUALIZER
t12dB at 30, .150, 500, 1500 and
1 0,000H2
2
