MD SPORTS YUS450_018M User manual

Assembly Instructions
MODEL
YUS450_018M
Menards
www.medalsports.com

English
SAFETY INSTRUCTION
YUS450_018M 1(Continued on the next page) www.medalsports.com
Adult Assembly Required.
CHOKING HAZARD - This item contains small parts. Not suitable for children under 3 years.
WARNING
X2
At least 2 adults needed No children in assembly
area
Keep away from pets in
assembly area
Do not use or keep
product outdoors. For
indoor use only. No
wet/humid conditions.
•
•
•
•
Product must be assembled by an adult before use.
Do not over-inflate.
Not to be used as a floating device.
This product is for youth use only, it is not intended for adult training.
WARNING
•
•
Not to be used by children without adult supervision.
To reduce the risk of suffocation, drowning or serious personal injury:
- Adults must always stay within reach of children while playing.
- Keep product away from small children when it is not inflated.
Child Safety
•Play only in an open area away from sharp objects, with at least a clear space of 10ft (3m) around the product.
Product Protection
10ft (3m)
Target Bag
10ft (3m)
IMPORTANT NOTICE!
This product is intended for INDOOR use only.
Please do not sit, climb or lean on the product.
Please only use spray furniture polish to clean the exterior surfaces of the product.
This is not a child's toy, adult supervision is required for children playing this game.
1.
2.
3.
4.
•
•
•
Avoid contacting the inflatable bag with sharp objects or hot surfaces which could cause injury to your hands.
Remove sharp objects from your body which could damage the product, such as rings, watches etc.
Make sure that there are no sharp objects on your shoes which could damage the product.

PRE-INSTALLED PARTS
English
PARTS IDENTIFIER
YUS450_018M 2(Continued on the next page) www.medalsports.com
Inflatable bag with sensors
1
x1
FOR FIG. 1
ON/OFF
Control box
2
x1
FOR FIG. 4
Vinyl patch
3
x2
Inlet cover
P1
x1
FOR FIG. 1
Inlet cap
P2
x1
FOR FIG. 1
PART NUMBER FIG NUMBER
QUANTITY
PART
PART NAME
BEFORE ASSEMBLY
Find a clean, level place to begin the assembly of your product.
Verify that you have all listed parts as shown on the part list pages.
1.
2.
HOW TO USE REPAIR PATCH?
Deflate product.
Clean defective area.
Cut round or oval patch.
Remove paper backing.
Apply sticky film to repair area. Squeeze out all air bubbles.
Do not inflate the product until the patch has been fixed in place for at least 20 minutes.
1.
2.
3.
4.
5.
6.
This repair patch is not a toy. Keep away from children.
WARNING

English
ASSEMBLY
YUS450_018M 3(Continued on the next page) www.medalsports.com
FIG. 1
FIG. 2
1
x1
x1
P1
x1
P2
Pre-installed
Pre-installed
FILL THE BASE WITH WATER
Base
WATER
1
P1 P2
P1 P2
INFLATION
DO NOT OVER INFLATE
Cover nozzles
Target Bag
Neck
Target Bag
Target Bag
Diameter MAX: 18 inch
Diameter MAX: 13 inch
Base
Inflation using an air pump must be performed by an adult.
Do not use a high pressure pump or a pump for car tire.
The maximum air pressure for the inflatable pods are 2.0 kPa.
Check before each use and at regular intervals.
•
•
•
•
WARNING

English
ASSEMBLY
YUS450_018M 4(Continued on the next page) www.medalsports.com
FIG. 3
FIG. 4
2x1
ON/OFF
Bag
Scoring
Sensor Wire
ON/OFF
2
ON/OFF
ON/OFF
8 pins
Scoring Sensor Wire
Control Box
Note: Connect the Scoring
Sensor Wire to the Control
Box, then put it in the bag.

English
INSTALL BATTERIES
YUS450_018M 5(Continued on the next page) www.medalsports.com
Battery Box: Remove the battery cover and insert 2 “AAA” Batteries into the battery box.
( 2 “AAA” Batteries not included).
Reminding:
● Batteries must be installed according to the correct polarization (+ and -) required.
● Please clean the battery contacts and also those of the device prior to battery installation.
● If the game will not be used for a long period of time, we recommend that the batteries should be removed.
WARNING
Require 2 pcs “AAA” Batteries (Not included).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc),
or rechargeable (nickel - cadmium) batteries.
1.
2.
3.
When “ON / OFF” is pressed once, it starts up, when pressed and held for 3 seconds, it shuts down.
ON / OFF
GAME INSTRUCTIONS
NOTE: The game will automatically power off if it is left idle for 5 minutes. It is recommended that you turn off the
Control Box and take out the battery when not in use.
NOTE: Pressing the “ON/OFF” key at any point for three seconds will turn the game off.
Press the “ON / OFF” key to start the game (playing the boot sound, and 3 LED lights will light up for 3 seconds).
Game time is 2 minutes.
After the game starts, one of 3 LED lights will light up for 2 seconds randomly. (If it is not hit within 2 seconds,
another LED light will light up randomly).
After the game is over, click the ON/OFF key to restart the game.
1.
2.
3.
4.

English
DISCLAIMER
YUS450_018M 6(The last page) www.medalsports.com
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
NOTE
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
•
•
•
•

www.medalsports.com